Toyota Tacoma Angled Axle Shim DIY Installation
HTML-код
- Опубликовано: 16 сен 2023
- Does your Tacoma have a lift on it with some driveline vibrations at specific speeds? If so these angled axle shims may just solve your truck's vibrations. I'll show you how to disassembled and re-assemble the rear leafsprings from the axle in order to get these pieces installed.
Torque Specs - 3rd Gen 4x4:
U-Bolt Shackles: 73 FT/LBS
Leaf Spring Rear Shackles: 89 FT/LBS
#toyota #toyotatacoma #3rdgentacoma #trd #trdsport #4x4 #accesscab #liftedtrucks #liftedtruck #diy
So good and the best brother... Becareful..🙏🙏🙏
I'm gonna install this, I'm going to try and do it by dropping the rear-end and holding the frame on stands.
Great video.. I installed a deaver stage 2 on my Tacoma, constant load is 600lb. Getting a slight vibration, will the this rectify the problem???
There’s so much science to driveline vibrations it’s hard to tell really.
Hello, Where can I buy that bum stop kit with the u bolts? I bought one and it was very short
Wheelers Off Road
So was your pinion pointing UP too much?? I think you installed them facing the wrong way…my truck I had to get the pinion to point down towards the ground more to rectify the angles..
Dang I think you’re right. Guess the folks on TacomaWorld have some bad advice. Time to take it apart again…
@@randomrebuildsdid it work?