Видео

Hey! sorry I don't know. I can't keep up with all the new stuff XD haha

Hi sorry I don’t know.

Go get it! 😂 ❤

Have a read around the comments, I think some ppl have tried. Unsure if successful. Goggles 2 would only be the front section of the goggles as the top ones pull out directly

It was pretty damn quiet compared to a 4S quad. it was very fun to fly but quite honestly I don’t know if it’s the best. I haven’t flown it since. I recently got into 1S tinywhoops, about 10g lighter than this one, and those are even quieter, but visuals might not be as good as walksnail / DJI

Hi. No I don’t think I have a full setup video. I do have a tuning video but that may be out of date now. If you get bnf version it’s pretty much setup already you just need to bind it to your transmitter

Hi you can do it either ways. 1) GoPro plug to the balance plug of the lipo. Or use a different plug which goes GoPro to solders to the main positive and negative pads of your flight controller. Both plugs are included in the kit

Hi the link to the antenna is in my description below. That one works great for the o3 air unit.

Where are you from? It’s actually $65 USD ($90 Canadian dollars) and the 39 pieces of titanium screws for extra weight reduction TPU pieces are what brings the price up.

@@PattyFlipz I looked it up at the site listed in the comments 90$

@@PattyFlipz ok sorry.my mistake 65 is more reasonable

No worries! Thanks again for the interest

Yes that is right

You’re welcome!

LHCP in your goggles will work with the stock o3 antenna too but maybe not as efficient as the stock goggle antenna and will be a bit of signal loss possibly. Be the best if you change it on the quads end to match, where LHCP is more common options for sure. Good luck

yes!

Thank you so much. And thanks for watching! Great Smokey mountains, I definitely need to look this up 🤤

Great idea. I think the stabilizer arms are probably around 4g each.

You probably can but I would stick with the standard antenna most likely

In the rate profile tab - Besides cutting throttle scale to 50-60% have you tried throttle expo? The more you increase the more dull your throttle stick will feel when moving it

@@PattyFlipz I set throttle scale to 90% because if I reduce it to 50 or 60% it is hard to take off.... Both Throttle MID abnd EXPO I have tham at 0.57 Everyrthing works fine with the rates I appled, but thew problem is that it is very, very hard to keep the same flying level, Any idea?

The idea is you want to tune your throttle until hover point is around mid stick (1500). And as for the quad not keeping level or bobbing up and down, it’s all about practice and more practice. A turn, going over a table, wind will all effect the drone. It’s definitely not as sophisticated to hold a hover as a DJI avata etc.

​@@PattyFlipzwould the gravity option be of help?

For sure!! 😂 thanks for watching

I’m spraying it on some new builds right now, but I won’t be doing a full test / video. I don’t doubt the product but I doubt my spray coverage technique perhaps 😂 For me, I’m personally going to use this spray as a precaution when I fly and land in wet grass, happen to fall in a puddle, or flying in rain. 👍 not flying into a waterfall, but closer to it! there are some other review videos out there already who do all the tests 👍 go check it out

@PattyFlipz if it's not certain...then the old ways of conformal coating still the best way to waterproof right? Rather then a spotty protection

@PattyFlipz but some protection is better then none. Thanks! don't damage your drone

Thanks! Hope you are enjoying your p25?

@PattyFlipz I'm loving it! Imma have to get me a few more colors soon, just to have more flavor. But definitely also interested in the pg5.

Probably need to take it completely apart and reassemble. I guess works best on naked vtx

Gladly! 😂🔥🔥🔥

There is just “enough” room for everything. 😂 thanks man looking forward to your order.

Hi, I use to fly a 1.6” and tried to fly it pretty far without a gps, I found that really fun because it was less intrusive to the environment and unnoticeable to animals or humans. p25 is a 2.5” quad and has a nice sweet spot for freestyle performance and some efficiency for what it is. So basically it’s my burning desire to push the limits of a micro quad and see how they fare. I also have a 4” LR and 7” but it’s crazy how I prefer flying the 2.5” still. The 4” LR I have, the footage is unusable with any slight wind. 7” is heavy and takes up the entire backpack and same 15 minute flight time as p25! (With a 4000mah 6S)

Hi, sorry no I don’t. It’s a bit too much investment so I just sell the frame kits. it’s fun to build for sure 👍 and if it’s your first build, it’s a great first build

I think this quad is around 185g with the naked GoPro . So there’s a bit of room to play with a small 4s battery. If you care about every gram being under sub250 I would recommend filming with a naked o3 air unit. Also, when you film inside and don’t go outside there are no rules with weight. At least in Canada!

@@PattyFlipz thank you 🙏

No problem! Hope it works out 👍💪

You’re welcome!