BCM mod 0 is superior in all ways, in those options. I have one on my fx9. The grip is great and natural. It also is holding a spare battery and a couple hex keys in the storage.
Love the channel! Your content is legit but with your overall look and that accent it makes me feel like I got some covert-ops armorer breakin it down for me like a Russian Q 😂😂😂
It's the same process as any other AR-15 pistol grip. Unscrew it using a 3/16 hex wrench and carefully lift the grip as to not lose the safety detent pin and spring. Repeat the process in reverse with your new pistol grip. Brownells did an amazing tutorial on this process on their channel - much better than how I explained it here in this comment.
I have a k2 on my fx9 with no issues
BCM mod 0 fits the fx9 perfectly. That's what I'm running.
Thank you for the comment! Been trying to find a solution. Going to look into this.
Does yours have the little like wing/plastic sticking out or just the handle I hope that makes sense
a2 grip with the finger groove sanded off and front and back stippled
I am not that handy with the tools, just never learned enough. So I get a better grip
BCM mod 0 is superior in all ways, in those options. I have one on my fx9. The grip is great and natural. It also is holding a spare battery and a couple hex keys in the storage.
Bcm stock and short vfg are also great, though I am partial to b5 systems too
What did you end up going with on the fx9
I’d like to see BCM gun fighter grip on the fx-9. Id like to know how the reduced angle feels when shooting it.
Mod 3 seems to be the best one...
Which one is best? Great video
Best one did not fit, lol. Tried BCM but angle is not for this pistol.
ERGO makes a “flat top” grip for the FX9
I will check it out. Magpul grip is not working well. BCM next
Practical Weapons Hogue also makes a nice flat top.
Is that the upgraded charging handle? How do you like?
This is still the original one, I did not install the two sided handle yet.
Hogue fits the best.
Gregg, do you have the Hogue Overmolded Pistol Grip for AR-15? Thank you!
Can the hand guard change to a regular AR platform at the correct length
Is there something you can buy it put attachments on the side of the gun? Mine does not have side rails.
Extar sells rails for the EP9 handguard - that is what I bought.
Love the channel! Your content is legit but with your overall look and that accent it makes me feel like I got some covert-ops armorer breakin it down for me like a Russian Q 😂😂😂
Funny, thanks! That is the idea...
how do you tighten up the pistol grip mine wont tighten up .
Larry,Curly,Moe
heat up your "dove tail" on the grip... seen it work well...
Try BCM
+mike mihelich they make some of the best grips
@@PracticalWeapons so will a Gemtech 9mm GM-9 (1/2 x 28 tpi) Threaded Inert Fake Suppressor fit?
@@mr.m2556 I cannot answer that question - was not planning to remove the fax 3" supressor on my FX-9 pistol.
show us how you replace the pistol grip on a fx9
Unfortunately RUclips no longer allows modifications to be shown. Still, there was nothing special to tightening the grip screw on the FX 9
It's the same process as any other AR-15 pistol grip. Unscrew it using a 3/16 hex wrench and carefully lift the grip as to not lose the safety detent pin and spring. Repeat the process in reverse with your new pistol grip. Brownells did an amazing tutorial on this process on their channel - much better than how I explained it here in this comment.