Boating Hack for Electric Trim Failure - How to Manually Lift An Outboard Motor

I have been boating for almost 2 decades and just came across this life-saving hack. How to easily raise your outboard motor when the electric trim fails. Thanks for watching!!

[@ffemtx47]

The yappity yappin stops at 3:40 and the "fix" begins at 3:43.
You're welcome.

[@londland5146]

Thku...ughhhh

[@gracechristianvideo]

Exactly. A 6-minute video that should've taken 45 seconds.

[@eamonnocarroll5866]

Thanks - much appreciated

[@bartmaka9520]

Thanks for the video my motor just died and i found your video your life saver

[@michaelscheidell8210]

Thanks for the information I didn't know that I need to put fluid in my pump to see if it's my problem I have power to the motor but couldn't get to the motor

[@jimmykastrinos312]

thank you, facing the same problem!

[@slowjamcdub]

Thank ya!

[@JoseyWales845]

Great explanation. Thank you. That just what I needed to raise the leg manually.

[@GlennConner]

Glad it helped. Thanks for watching!

[@hanslepoeter5167]

thanks. That's good to know. I have a squeaky sound in the tilt, when i help it works but this will get me out of the water when it stops working.

[@budconner8197]

Good information to know about thanks for sharing 👍

[@chrisdriver4083]

Awesome man I didn't know that either

[@gyulahohmann3123]

Awesome mate, gotta go work out where mine is located on my johnson 50hp coz they're all different , thanks mate 😎👍from Oz. Australia

[@GlennConner]

Should be pretty close to the same. I wish I would've know this. Would've saved me a couple hours on the boat ramp. Thanks

[@ryanstanek1554]

Awesome video, thanks

[@JaredCarrica-tf2fd]

Thank You!!

[@russellgardner2557]

Motor stuck in down position (Merc 115 Optimax) did hit the ramp coming out, but not bad. Got the boat home ... motor runs but will not tilt, suspect no/low fluid level. Cannot access the fill port and need to tilt motor up ... going to try this ..... Thx.

[@russellgardner2557]

Found the screw valve, motor went down further but to heavy for me to lift. I'm in a bind ...

[@GlennConner]

@russellgardner2557 try a ratchet strap from a tree or another truck or something.

[@chiefoutdoors]

tried this with mine and i couldnt. felt like theres still pressure in it, but no oil came out. so im hoping the assemblty or something didnt break inside.

[@amychartraw1]

It's not a "hack." It's a standard function on every factory hydraulic trim and tilt. Fyi, the parking brake on your tow vehicle is not an anti-roll down the hill "hack." Just sayin'. As an aside, if your skeg hits the ground while on thr trailer either the motor is mounted too low (you can google proper set height) or the trailer is setup wrong. Close is fine, but if your transom saver or other prop device fails going down the road you don't want to be able to drop anchor and plow a furrow thereby destroying your lower unit.

[@aaronreaka9024]

If your trim motor is bad my comment is invalid

[@MikeSmith-nu9wt]

I cant believe your showing everyone your johnson !!

[@GlennConner]

Well it's something to be proud of.

[@YvesLopez]

Get to THE POINT I’m going to sink…. Damn …..