They used to be with their crappy Jatco automatic transmissions, but ever since 2016+ they've been using their own designed automatic transmission which is way better than they used to be
I had the same problem. I did some research and found out it was the transmission control module that sits on top of the transmission. Apparently they go bad. I replaced the module and it's back to normal.
kingo290 where the hell that tcm located at? It’s pretty obvious in 2007-2009 but not on 2004. I have the same problem and it’s been two weeks and I haven’t found the TCM
Daniel Andujar I had to rebuild the transmission. The main cause is a seal on the transmission oil pump. The seal goes bad causing friction clutchs to burn in 3rd and 4the gear. I got a full rebuild kit from rock auto. It’s not easy and you need special tools to do it
Do you happen to know who made the Sports Automatic Transmission for the Mazda 3 SP23 First generation (BK; 2003-2009) using Mazda L (L3 SVT) 4 Cylinder, 2.3 Litre engine? Is it a Jatco Transmission?
i had the same problem. but it was my rear brake pad sticking to the rotor causing it. if you had a break job, check if its them before opening the transmission
Oh balls.! Mine when it's cold on Startup you go down the road it will not go into 4th gear.! But go about a quarter of a mile down the road pulled over turn the key off after the Transmissions warmed up and it goes right into 4th gear and I'm fine after that until the engine cools back down with the transmission then the AT light will come back on
I put it into drive and it just revs like it's in neutral I have 67,000 km help it the transmission module or do I need a new transmission automatic 2.0
its been a while since you posted this video but id like to tell you ive had this same issue but with 3rd and 4th gear. I can can tell you that you will need a entirely new transmission because what is messed up is not repairable by itself. Ive been cruising around in 3rd and 4th gear for the past six to eight months
Anthony Sterling That's what I did. Lucky enough I found a transmission in the junkyard with a good mileage. Did not took the chance to rebuild it for I know it will cost me more.
Anthony Sterling it's actually the TCM transmission control module. You have to replace it. It stays in 3rd and 4th gear for (safe mode) so you don't blow your engine.
Brenden O'Leary didn't bother to open the transmission. Rebuilding the transmission would also cost as much as buying a new one. I just changed my transmission.
Most common problem is with the TCM. I ended up replacing both my TCM and transmission because of some solenoid issue. Mechanic says Didn’t have to change the tranny if I replaced the TCM earlier.
question right have mazda 3 2006 taking reverse but not drive like skip dat gear n wouldn't move have press gas dead hard multiple times for it buged wats problems ? help please
Dangelo Etienne from what I have learned with the problem I had with my transmission is to check the TCM first (Transmission Control Module). Have you tried scanning your car on a OBD?
I have a 2007 Mazda 3 and when I am coming to a break if doesn’t down shift right it goes from 4th gear to 3rd gear to 1st gear skips 2nd gear what may cause the problem??
Very good video. Bad TCM is a common transmission problem in Mazda vehicles.
They used to be with their crappy Jatco automatic transmissions, but ever since 2016+ they've been using their own designed automatic transmission which is way better than they used to be
I had the same problem. I did some research and found out it was the transmission control module that sits on top of the transmission. Apparently they go bad. I replaced the module and it's back to normal.
kingo290 where the hell that tcm located at? It’s pretty obvious in 2007-2009 but not on 2004. I have the same problem and it’s been two weeks and I haven’t found the TCM
@@murhafsukkar9555mazda3 2004-2005 tcm is integrated with the pcm
@@2002maximase pcm??
@@murhafsukkar9555 Hi i have a 2004 mazda 3 and AT light is on sometimes
And sometimes it change from 1st gear to 4 do you fix yours??? And what was??
Daniel Andujar I had to rebuild the transmission. The main cause is a seal on the transmission oil pump. The seal goes bad causing friction clutchs to burn in 3rd and 4the gear. I got a full rebuild kit from rock auto. It’s not easy and you need special tools to do it
Make sure your batteries are good, solenoids need the right volts to function, batteries are in series so you wont jnow the main one is out
Check codes first, make sure no sensor gone bad like speed sensor
Automatic Transaxle Warning Light On
Do you happen to know who made the
Sports Automatic Transmission for the Mazda 3 SP23 First generation (BK; 2003-2009) using Mazda L (L3 SVT) 4 Cylinder, 2.3 Litre engine? Is it a Jatco Transmission?
Probably Ford..
i had the same problem. but it was my rear brake pad sticking to the rotor causing it. if you had a break job, check if its them before opening the transmission
If brake pad is sticking, wouldnt the car be slowing down ?
I have the same issue. I changed solenoid A & D
Esta en modo de emergencia, son los selenoides que están en corto circuito
Replace the transmission control module. It's located under the battery
Mazda 3 2004 model has tcm??
How much it cost to fix mines is a 2012
Oh balls.! Mine when it's cold on Startup you go down the road it will not go into 4th gear.! But go about a quarter of a mile down the road pulled over turn the key off after the Transmissions warmed up and it goes right into 4th gear and I'm fine after that until the engine cools back down with the transmission then the AT light will come back on
Richard Herrman AB- typical mazda problem. Might be the control module also
How do I fix this
That’s what I have!
I put it into drive and it just revs like it's in neutral I have 67,000 km help it the transmission module or do I need a new transmission automatic 2.0
I need my car 🚨
How about in reverse?
A little jolt
Exactly what am facing thats my exact dilema, what did you do about it ?
Got a used transmission
Same problem with my mazda
My mazda 3 engine light on, what did I do to get my car back to normal. It jerks while I drive it?
Dastardly cute have your car scanned first. But normally in that case you might want to have your spark plugs and ignition coil check.
@@MangPablo ok thank you
Anyone fix there issue without purchasing a new transmission?
I have a Mazda 3 2006 there is no TCM under my hood where is it located and could it possibly be anything else
Carniqua Triggs torque converter
girl gr if it's a 4 speed the tcm and pcm are one unit it's on top left side of the fuse box
There's not transmission control module you need to replace the computer for "2006"
Hello, were you able to resolve the issue?
Some sensors. . ? Easy fix
its been a while since you posted this video but id like to tell you ive had this same issue but with 3rd and 4th gear. I can can tell you that you will need a entirely new transmission because what is messed up is not repairable by itself. Ive been cruising around in 3rd and 4th gear for the past six to eight months
Anthony Sterling That's what I did. Lucky enough I found a transmission in the junkyard with a good mileage. Did not took the chance to rebuild it for I know it will cost me more.
Anthony Sterling it's actually the TCM transmission control module. You have to replace it. It stays in 3rd and 4th gear for (safe mode) so you don't blow your engine.
Could be the transmission speed sensor also. It will cause the car to stay stuck in 3rd gear. Easy and cheap fix
Is there OBD2 transmission code ? There are lots of sensors on cars.
@@jayvega8586 what one would that be do uou know part number for a 2006 mazda 3s auto ?
Ijust change my solinoids and its the same thing it slips on me on 3rd gear and won't gear at all it stays on 3rd. So it should be the module Tha
Did you fix your problem ?
the same thing happened to my sister's car what ended up being your problem
Brenden O'Leary didn't bother to open the transmission. Rebuilding the transmission would also cost as much as buying a new one. I just changed my transmission.
I have a same problem with my mazda3 2009
hey my man, were you ever able yo resolve this? been having the exact same problem with my car it's insane
Most common problem is with the TCM. I ended up replacing both my TCM and transmission because of some solenoid issue. Mechanic says Didn’t have to change the tranny if I replaced the TCM earlier.
What's TCM? Thanks
@@caveman4093 transmission control module
My automatic transmission Mazda 6 does not reach gear 3 and above plz help me
master tv have you scanned your car?
master tv solenoid c
master tv did u ever fix ur problem?
question right have mazda 3 2006 taking reverse but not drive like skip dat gear n wouldn't move have press gas dead hard multiple times for it buged wats problems ? help please
Dangelo Etienne from what I have learned with the problem I had with my transmission is to check the TCM first (Transmission Control Module). Have you tried scanning your car on a OBD?
I have a 2007 Mazda 3 and when I am coming to a break if doesn’t down shift right it goes from 4th gear to 3rd gear to 1st gear skips 2nd gear what may cause the problem??
For that model car I think it is also the TCM. Common Mazda 3 problem.
Not the same car but my Suzuki reno 2008 same problem time too trash the car
Your in manual mode put the car in D