Размер видео: 1280 X 720853 X 480640 X 360
Показать панель управления
Автовоспроизведение
Автоповтор
Cable still plugged in ? 😅
The easiest way is to use the air duster to blow air into both sides.
Nice tip
What is the grease used? How frequently should we grease?
Any food safe grease should do the trick.
I would recommend a small amount silicone grease. It is generally food safe/non-toxic and lubricates metal, plastic and rubber.
Always remember to clean your discharge chute. Gets very messy if you don’t
After I removed the burrs and replaced as shown, the grinder now grinds very coarse, even at setting 0 it looks like 50
Please follow ruclips.net/video/UC7E52RtfMQ/видео.html to get to the zero point first.
@@miicoffee Perfect thank you so much
Is it make a lof of fine ( is it focus for texture )
I can’t get the chute off for the life of me. I unscrewed everything
Same here it is stuck. It’s like there’s a clip inside holding. All screws removed and it won’t come out
same! the video conveniently cuts during this step with a "just use a little bit of force..." explanation, but all that stuff is plastic... and you can see the outer chute binding on the inner chute... this might be the achilles heel of the DF54
Maybe disconnect the grinder from power before working on it?
Cable still plugged in ? 😅
The easiest way is to use the air duster to blow air into both sides.
Nice tip
What is the grease used? How frequently should we grease?
Any food safe grease should do the trick.
I would recommend a small amount silicone grease. It is generally food safe/non-toxic and lubricates metal, plastic and rubber.
Always remember to clean your discharge chute. Gets very messy if you don’t
After I removed the burrs and replaced as shown, the grinder now grinds very coarse, even at setting 0 it looks like 50
Please follow ruclips.net/video/UC7E52RtfMQ/видео.html to get to the zero point first.
@@miicoffee Perfect thank you so much
Is it make a lof of fine ( is it focus for texture )
I can’t get the chute off for the life of me. I unscrewed everything
Same here it is stuck. It’s like there’s a clip inside holding. All screws removed and it won’t come out
same! the video conveniently cuts during this step with a "just use a little bit of force..." explanation, but all that stuff is plastic... and you can see the outer chute binding on the inner chute... this might be the achilles heel of the DF54
Maybe disconnect the grinder from power before working on it?