You didn't put on the wire springs on top of the pads? Also, the caliper needs to be aligned correctly for the ping on the back of the pad to fit into it correctly since it wasn't shown in this video.
The front caliper bolts are torqued to 37 ftlbs and rear caliper bolts to 17 ftlbs based on your videos. Is this correct? 7:35 on this video: ruclips.net/video/RuXkt6hY6Yk/видео.html says 37 ftlbs for the front caliper bolts. Would like to verify.
Hey buddy, not for nothing but you do entirely way too much to do just that little bit. You took off that rotor four times talking about cleaning it but then you dirty did it again you didn’t put the springs back in I think you need to work on your videosand maybe figure out what you’re forgetting before putting on the video
√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money
Are my calipers gonna magically turn fresh red when I put the wheel on?! That’s killer! 🤙🏼🤙🏼
I can't get the piston to depress
If only the rotor screws came out this easily. Folks, odds are you’ll have to drill yours out. Try lubricant and heat first, good luck.
+@zachsmith6279 Thanks for watching our video! 1aau.to/m/Shop-TRQ
What about the pad wires? And that new red caliper magic is legit
Regarding the pad spreading springs are they suppose to be pointing towards each other or away from each other?
You didn't install the pad spreaders. But good video.
What is the grease and is it a specific type of grease for the car?
Thanks for video. But, seem to have forgotten the brake pad wire clips.
You didn't put on the wire springs on top of the pads? Also, the caliper needs to be aligned correctly for the ping on the back of the pad to fit into it correctly since it wasn't shown in this video.
99% of mechanic does not do this. You would be lucky to have them give you the right product.
So the piston doesn't need to be depressed back into the caliper? Good to know.
I watched the video to see where you put the spring clips. I saw you take them out, but you did not put them back in.
The front caliper bolts are torqued to 37 ftlbs and rear caliper bolts to 17 ftlbs based on your videos. Is this correct?
7:35 on this video: ruclips.net/video/RuXkt6hY6Yk/видео.html says 37 ftlbs for the front caliper bolts. Would like to verify.
Nice work
Where are the springs lol😂 I won’t be driving that
Hey buddy, not for nothing but you do entirely way too much to do just that little bit. You took off that rotor four times talking about cleaning it but then you dirty did it again you didn’t put the springs back in I think you need to work on your videosand maybe figure out what you’re forgetting before putting on the video