CNC Music! - How you can make your machine play a song.

I go through the steps on how to covert a midi file to g-code using an online converter.
Midi to G-Code Converter:
www.ultimatesolver.com/en/mid...
Midi Files (for you nerds):
www.midishrine.com
Have Fun!

[@vinodgopivlogs6986]

Nice nice job

[@BrilliantDesignOnline]

I was just looking for someone who had 'made CNC music', so I was shocked that there was a site to allow you to convert midi to g-code..The entertainer was a bit lame, but I can see the potential. Thanks for sharing all the beginning section!

[@No1sonuk]

It didn't sound anything like The Entertainer to me...

[@EZ_shop]

Ha ha! That's so cool, I have to go try it out.

[@florianrohner2263]

Very cool!!!

[@TheCarryHandlePodcast]

...thats amazing...

[@pmd1973]

Assuming C&C Music Factory's catalog would be stricken for copyright

[@bgwmachine]

Sorry guys, I just realized that I misspoke about the steps/mm - I doesn't have anything to do with the steppers (well to a degree, but it isn't solely relient on the steppers) it also depends on your leadscrew, ballscrew, belt/pullies, etc that drive your machine. You'll have to figure out this in relation to your machine. Sorry again - total brain fart.

[@OneTequilaTwoTequila]

will this work with AC servos?

[@jdparden]

Where did you get your dust boot!!!???

[@bgwmachine]

J. D. Parden I made it! Not sure if I made a video on it or not, but just used Fusion 360, magnets and some hardware from the store.

[@LazuliteLol]

this isnt command and conquer...

[@OldEnglishWorkshop]

Ha Ha very good