Here I was thinking this was a rare fault and my video wouldn't help anyway. I ended up redoing it with chopped pieces of pvc electrical trunking. The silicone jn thr pc keeps shifting causing it to stop working again.
I am thinking plastic or teflon might be a better idea here, using conductive washers might pose risks of shorting your contacts, however small the chances are.
Great video man. I have a similar issue, not exact. Battery is holding a charge, 2 bars left when I click the button, power tools work with the battery. The battery just won’t charge. When I put it on charger nothing lights up. I tried jumping it but still nothing. Any idea?
So I opened the case and found 1 of the pins wasn’t alignment properly. I realigned it and it charged for a few minutes, and then back to the same problem. I’ve tried jumping it and it still won’t charge. I’m getting about 18v out of b+ and b-, and 10k out of b+ and th with the thermistor check. 2 lights show when I press the button. Tools still work as well. I’ve tried a 20v tool and a 60v tool. It just won’t charge.
@@tmuney08sounds different from my fault. Mine would only run some tools such as a torch but wouldn't run power tools and wouldn't charge. Did the pin bend back maybe?
Great Job Arjuna ...I love your Theology Unleashed Contents.
Just wow. Thank you sir, you just fixed my battery. Same exact problem
Here I was thinking this was a rare fault and my video wouldn't help anyway.
I ended up redoing it with chopped pieces of pvc electrical trunking. The silicone jn thr pc keeps shifting causing it to stop working again.
Thankyou for the video, just fixed my 6amp with a washer. @@legacyelectrical
I am thinking plastic or teflon might be a better idea here, using conductive washers might pose risks of shorting your contacts, however small the chances are.
That's a good point. I ended up redoing it a few times and added some chopped up prices of pvc electrical trunking
Great video man. I have a similar issue, not exact. Battery is holding a charge, 2 bars left when I click the button, power tools work with the battery. The battery just won’t charge. When I put it on charger nothing lights up. I tried jumping it but still nothing. Any idea?
Have your tried testing it with a multimeter to see if one of the pins is different from a good battery?
So I opened the case and found 1 of the pins wasn’t alignment properly. I realigned it and it charged for a few minutes, and then back to the same problem. I’ve tried jumping it and it still won’t charge. I’m getting about 18v out of b+ and b-, and 10k out of b+ and th with the thermistor check. 2 lights show when I press the button. Tools still work as well. I’ve tried a 20v tool and a 60v tool. It just won’t charge.
@@tmuney08sounds different from my fault. Mine would only run some tools such as a torch but wouldn't run power tools and wouldn't charge. Did the pin bend back maybe?
Question for ya. My push button on the check fuel gauge is stuck. Any ideas on how to unstick it?
You mean for checking how much battery is left? I can't imagine how to fix that.
Throw some lube in there😄