How To Install A Flat Top Piston In Your Minibike! How To Install Piston Rings! In-Depth Guild!
HTML-код
- Опубликовано: 14 окт 2024
- Hope you enjoyed!
********Disclaimer********
Please do not try to re-enact or recreate anything you see in these videos.
Guido does not take any responsibility for injuries or equipment failure created by doing so.
ALL GUIDO CONTENT IS FOR ENTERTAINMENT PURPOSES ONLY.
********Disclaimer********
This is a older video so info may be a bit off! Go easy on me lol! Check out the newer videos here! • Mini Bike Videos
#minibike #piston #sub2guido
Make sure to like and SMASH that subscribe button!
This is a older video so info may be a bit off! Go easy on me lol! Check out the newer videos here! ruclips.net/p/PLQiOg6Lr31OL6evrjsewgpU2eDsfJSWw0
Congrats bro! On the road to 1000!
Hey thank you my man!
Nice video! Idk if it’s just me but is that washer from the governor still in the block?
Lol it is not😂 it was just the glair of the light.
what size do i get for my rod and piston so it all fits? ive seen .550 or .570 for pistons and 3.308 or 3.328+0.20 for rods. So what sizes do i get?
@@grumpythefortmaker9510 it depends what you wanna do if your just doing a stock replacement I would get the stock length 3.308.
@@grumpythefortmaker9510 for pistons you should be good with 570 or below any more you might have to do a longer block for a longer stroke
@@Guido19 also what gasket size should i go for?
When I installed mine I got rlly bad kickback and compression when with lash set right
When you pull start it make sure to pull start it on the compression release it won’t be as bad and I would also check the valve lash again because it can move!
I can’t get the piston in for some reason been trying for a hour even with the compressor I’m losing my mind
Hmmm very strange only thing I can think is you may need to trim your piston rings a bit. You would need to get a piston ring trimmer and then put it in the cylinder without the piston to see if it goes in and if it needs to be trimmed
yo when i install my rod n flat top you think i should just take the piston rings off my old one and throw them on the flat top so i dont have to mess with clearances even tho this piston and rod i have fits hemi and non hemi 212
I would recommend getting and using new ones. there shouldn't be any clearance issues.
@@Guido19 alr perfect i installed my stuff a little while ago and it’s running perfectly mint, appreciate the video man it helped a lot and a lot of ur other vids have been super useful as well