Видео

Could you tell me what pilot jet you installed?

So 26mm fits? People on forums say it doesn’t.

Did this,,,oil still going into air intake

Can you tell me what the nuts are called that you use to mount the brakes?

Been standing by nibbi since the beginning off my mini bike adventures so about 5 years now

will mineral oil work?

Sounds GREAT after the new one 🔥🔥I'm getting one

Saying K&N was kinda making me mad a little bit lol it's definitely K&M lol

You keep saying "as you can see" but we can't see, because the camera is pointing at your friggin feet.

Could you link where you bought the brakes please?

Hey where did u get The filter for the gas tank?

I bought a mini bike but all I’m gonna do is build and improve. I think it’s a good hobby to stay busy #newlearner

Este método me funcionó recomendado 100%👌🥇

So I had a billet rod in my motor for a while but I just changed out my bearings because they were very worn out I also installed a flat top piston and I checked my oil clearance it was good at .003 and now when I tourqe down my rod bolts it won’t spin the only thing in the motor is the rod and crank and piston I’m very confused please lmk if you have any ideas what it could be

What other springs can I get for my impala? zzp is out of stock of the springs you have

What rear tire ?

Bro , what clutch is this exactly from Noriom , got a part #?

😊

What do you do if your throttle cable doesn't have a tip?

Piston needs to be top end before doing a lash valve on both intake and exhaust

I don't have .030 on my feeler guage

Roof rack looking clean do you have any noise from it? I got a 2012 LFX 9c1 recently; been watching all your Impala vids. Do you have one on the roof racks? Thanks mate

thanks!

Changed my coil and the thing started kickbacking so bad does having the coil gap wrong make that happen?

those other videos made it seem so much harder, i thought i was going to need a lift to do this job. your video was short, to the point, and for some reason not at the top of the list! thanks for uploading, im excited to take on this project now!

what size do i get for my rod and piston so it all fits? ive seen .550 or .570 for pistons and 3.308 or 3.328+0.20 for rods. So what sizes do i get?

What type of extension do you recommend for this as me and my neighbour tried doing this, but kept getting the spark plug socket. Stuck on the spark plug and couldn’t get it out.

Why did you unhook your battery? You don’t really need too

Can you put a link for the exahast pipe? I have the same build. Also great vid!

Hi, what does it mean when you turn on the car but it turns off, or it will turn on and if once put on drive it turns off ???

What size bolt will fit on the top?

Any suggestions for drippage on the overflow cap side?

Hey when this motor was fully built in the video what did you have inside I’m trying to build your motor seept by step

Question i have a racing centrifugal 12TH clutch with a 60 rear sprocket. Is that good top speed?

U tore up the clips because u didn't remothem correctly. I know they look like they're a 2 piece clip. Pop the center of the clip up then u can pull the whole clip by hand.

Can bicycle lube be used on it?

They must have listened to you I just got mine in today and it comes with the little nut for that bolt the spacers needing trimmed are still an issue but all and all it’s a great kit

Is this the mileage?

What is on the rear left side?

Do i need an alignment after i replace the trailing arm?

you should lowkey stretch your bike it would look sick

Did you have any problems with the clearance over time ??

Thank you, this helped!!!👏👍✌️❤️

What are the brake pads called?

Yo, awesome video, exactly what I was looking for! Just got my first mini bike today and I need these!

What front wheel is that?

Where did you get that chrome chain/clutch guard ?

Did you change the jets?

I've seen a few people with that kind of cold air intake before. Does it actually help? I feel like it would pull in a lot more hot air from the engine bay than stock

Is this the braking system?