Holley EFI - Rolling Anti-Lag Setup - From ANY speed

Quick video on how to set up rolling anti-lag on Holley Dominator and HP. Two ways to do it. You can do it from one set rpm/speed, or you can use a 1D RPM Rev Limit Offset table and set up to go from any speed you want. I am sure there are other ways you can accomplish this, but this is how I did it.
Wallace Racing Calculator Link
www.wallaceracing.com/calc-rpm...

[@br6ndonjones]

Does this apply to terminator x ? I can't seem to find a rev limiter offset option in any of the 1d or 2d

[@badcobraracing]

No, this is for Dominator and HP only. My suggestion is to ditch the Terminator and buy a used HP. The HP and Dom have so many more capabilities. You'd have to change your wideband sensor

[@mccannanthony7194]

The Terminator X V3 software is much different, you think you can help me out?

[@badcobraracing]

My advice is sell the Terminator and buy an HP. I am not familiar with the Term X interface and much prefer the Dom and HP. They have much better capabilities, it is well worth the extra cost. You can find a used HP for about $900.

[@GnarlyBlade]

I don’t run much boost for my application, it’s just a fun SBE street.. I think on pump gas I’m only targeting ~10-12 pounds
With this rolling antilag setup, can I expect to 2step to 8-10 pounds and as I continue to accelerate, after releasing the button, the waste gates will hold my boost psi to ~10psi? I’d go test it but it’s still a bit of a winter here so I’ll have to wait
Thanks for the video, I’ll be saving this for some testing late spring/early summer !