How to replace control arms on 2nd gen Dodge neon SRT4
HTML-код
- Опубликовано: 15 июл 2024
- Notice: You should not use chrome sockets on impact guns. Also make sure to wear your proper eye protection. Here is a video showing how to replace the control arms on a dodge srt4. This video just shows the passenger side but driver side should be the exact same. Took me an hour filming to do one side so could have been done in 30.
Авто/Мото
One the best explanation and Walk thru I've found
Glad i could help :)
Goodness me, best lower control arm replacement job ive seen so far. So easy too lol lucky
This video is everything!! Thank you!
I already knew how to do this, but I figured to just watch the video anyways lol. See if I learned anything new. I have to replace both front control arms, aswell as the steering rack, and passenger side wheel hub. So I figured why not knock it all out at once 😂
Excellent video. Thank you.
Glad I could help!
Great video... thank you for sharing.👍
That's what I'm here for :)
Oh my god just what I needed!
I made this video just for you! haha
DIY Ethan you the real MVP
Good 👍 job
Do you have the oil cooler lines recirculating with eachother. Since you did the oil cooler delete. Is that safe ? No problems?
Anything else you recommend I should replace at the same time? I got the moog problem solvers with upgraded spherical bushing.
I would say to do your tie rods while you're at it since the car will need to be aligned after anyways. Other than that it sounds like you're all set!
Great video. Just wondering if you have the torque specs for the bolts? Thanks.
Tight as hell
tightened the LCA bolts to 15 "ugga-duggas"? or was that 20?
can u do the rear control arms please? i just bought the dcr rear control arms and i wanna knw how to install them! thanks
Order new bolts that go through the spindle.
Thanks
Glad I could help!
God help you if either of the captive nuts inside the frame come loose when you start to loosen the bolts at the rear of each control arm! ☠️
What is the EASIEST way to remove BALL JOINT?
A press
Francesco Barbera so just unbolt it where the ball joint is and just use the press to get it out? No removing the vertical or horizontal LCA bolts/bushings?
If you can get the press in there yeah, but your best bet at that point is to remove the whole arm and press in new bushings too
Wow there’s literally no vids on how to do trailing arms on a neon. Currently replacing my own and thought, wonder if there’s any vids.... nope.
bro none of my bolts line up
You have to get all the bolts started after getting the ball joint started. Don’t tighten anything down until you have each bolt started. Then snug each bolt then tighten each bolt.
What up no torch specw
Specs