Honda Accord TPS Adjustment / FITV Fix
HTML-код
- Опубликовано: 31 июл 2024
- How to calibrate your tps on your 4 cylinder 1994 - 1997 Honda Accord. I also took the time to fix the fast idle valve while I was in there.
This actual tps calibration and FITV fix are identical on almost all 90's and early 2000's Honda and Acura. CRV, Civic, Integra, Accord, Prelude
If you would like to donate to the channel - paypal.me/thehondaresource?lo...
IG: / thehondaresource
hondaresource.com/
H22a1 H23A H22A4, H22A B20B, B20B4, B20Z2, B18B, B18B1, B18A1, D16Z6, D15B7, D16Y8, D16Y7, F22B1 F23A1, F23A, B18C1, B18C5, B18C 
Авто/Мото
You rock man! My 99 accord is just the same , a million thanks!
What’s up homie crazy I found this video for my cD5
Thanks will be going this tomorrow with greater confidence
Heck yeah!
Excelente vídeo, muito útil.
Good job. Appreciate that.
That was so smooth.
Thank you
Thank you it did help me a lot
Awesome!
congratulations, it helped a lot in my accord 94, F22B2 engine
Glad it helped!
Master.
Hello, did this to my car , the ground /first wire is reading 4.99 v as should … But the other 2 are both reading 14v??? How ? Battery only puts out 12?
Hi are you sure, that the way you adjust fast idle by turning it clockwise till it stopped down? Because I need to adjust mine and I am not sure what to do, because I need to adjust it.
Thank you
I appreciate you
For the fitv, what happens if the cover is missing? Like what type of symptoms would I have?
think you good
Need your help, i have 98 crv auto and we work the tps, map,and Iac valve, and before that my transmisión was working properly, now it dos not want to change gears till i hit 5000 RPM, i am wondering if its somerhing to do with the tps adjusment?
It very possibly could be, did you properly calibrate the tps?
I’m just going to leave that 777 likes where it is. Just know I liked it. Continue here
Thank you man
Hi sir I just wanted to ask for my honda accord 95 model, there's new map and tps sensor on my honda but still the check engine light came on,
what is the check engine light on for?
I set my TPS in .5 close throttle - open throttle is 4.3 is that ok?
Same happened to me! It wouldn't go past 4.3. I'm still having idling issues.
Did yours work?
Hi! Need your help. My 1998 Accord is same like yours. Problem is, if I plug out tps sensore my car works on otomatic gear d3 or d4 also 1 and 2 but speed stop on 70 km/h dont get over 2200 rpm. When I plug in tps sensore my car use only gear 2 and it gas and take back gas. Can be another problem? Some said it can be selenoid on otomatic transmission. It may Km sensore damaged. They Said like this. Thanks a lot.
I'm not sure. You can try to adjust the tps first since it's free!
My friend, is it the same work for a CRV 2000? thank you. please help. Im getting a P1121 on my CRV
Yes. Same deal
How significant is the volt meter when doing this job? I was changing the FITV and guna just swap out new TPS while throttle body was out
100% needed
Hey i have a 2000 honda accord my idle is surging from 1500 to 2000 rmp i cleaned the intake , throttle body the idle control valve i check the tps sensor but i cannot locate the fast idle valve can you tell me whats thr location
If it has a fast idle valve, it will be on the bottom of the throttle body.
Thanks it was a great help hopefully Full Throttle 4.45 it's good enough if you get time can you let me know
It should be fine
Thanks for the reply he runs a lot better @@hondaresource
Exactly what I needed in simple terms. Thanks
Thank you
Excelente vídeo yo tengo uno carro igual pero el tps viene remachado y no he logrado corregir el problema, espero poder hacerlo siguiendo el vídeo gracias por compartir.
buena suerte
Hola amigo lograste quitar el remache del tps el mio es igual y no se si se puede cambiar. Agradesco tu respuesta
Dear man, I have Accord the same to you. Diferent is MT. I change a lot òf TPS sensor but always code 7! I have head ache!
What the throttle body TPS Sensor close at .50 and open at 4.30 V. What could be the issues? TIA.
As long as closed is .5, it'll work fine
Hey phillip .question what position should the idle air screw be on the throttle body the one next to the map sensor.or do u have a video on the proper adjustment.thanks.
It should never be adjusted
@@hondaresource but what if it was moved by previous person .is there a fixed position I believe it should be .?
Wow super helpful
Need some help. I have. F23a engine and I'm getting a blinking d4 light
That's going to be a transmission code
My Honda Civic 2003 has a VTEC and the stopping at 3,000 RPMs is it the same concept
Sounds like you're in limp mode man
Sure wish this dude was at my house. 99 crv cranks then kills. Replace with new distributor, new main fuel relay, new plug wires an plugs,some deal that goes to back of ignition switch.new mass air flow sensor. Any help would be appreciated. Been on this thing 3 weeks. Compression all cylinders 180
Can you please give me some advice on my idle issue? Have a b20b in 99 model ek having a lot of up an down idle..change tps,map,oxygen,ECU,fast idle changed,iacv changed but problem still remains..however when I block of the iacv an I block the bottom hole in the throttle body which goes bk to the fast idle my problem goes away..how can I solve this problem? I tried blocking off the fast idle just the air ports but still it didn’t work the only way my problem is goin away is when I have the iacv blocked off an I place my finger to cover the lower air port inside the throttle body.. can you give some advice please 🙏 thank you or any one in the comments
Do you have the correct throttle body gasket?
@@hondaresource yes I do. Will fuel cause a problem like this also? Just today while driving check light came up an I cudn’t cross 40 the car was misfiring.. when I switched off the check light went away.also will a break in my harness cause this problem? Thank you 🙏 so much for your reply buddy..
What were the symptoms that presented where you needed to do this procedure?
Typically it will have a check engine light or if you replace the sensor.
Whats the name of the part that is attached to the bottom of the throttle body..? I need to replace that part .
Fast idle valve
I got the new tps the car still stalled it . Why
Is the voltage the same for all honda tps?( K,D,B,F series)
D B F J H are for sure the same. I'd have to look ok k series, but most likely it is
Just subbed. Thanks for this. I have a 01 accord v6 that is bucking when accelerating and rough idle under a load. Is this a good place for me to start? Thanks for this!
I would start with seeing what codes the car has first.
Hello, could you please share a video on how to replace rack and pinion on 1999 CRV, thanks
If I have one come in, I'll film it
I feel for you. Replace the rack on crv sucks.
what are you adjusting to make the voltage on the TPS go to half a volt?
moving the throttle wheel
@@hondaresourcewhat setting can you check them on
I've got a 94 accord. When I calibrate my new tps to .5 volts, it won't let me shift out of park. The shift lock doesn't work. No click when stepping in brake. At first I thought I blew a fuse, and searched and searched, until, long story short, it has to be closer to 1 volt for my car to be able to shift out of park. I confirmed this w my old tps, as well as my new. What gives? Why is this?
I'm not sure on that one
@@hondaresource well that's a bummer, because i was counting on having it for winter, and as it's been sitting in my driveway for the last 2 weeks
Tps sensor info at 3:10
Do u have a email i cant mail you a video of it im from the bahamas i watch you from far
Does it work for the Accord 2001 2.3l dx good fix.👽
Yes it should
I have a 2001 Honda Accord EX. Have had some idling issues and noticed it still had the factory TPS with the break away screws. I decided to change the TPS which obviously requires removing the throttle body. Removed the body today, changed the sensor, calibrated it within specs, and now it won't start? Cranks... but won't start. Tried the old sensor, checked fuses, TPS and MAP connections... nothing. I do not believe a signal is being sent to allow the fuel injectors to deliver fuel. Is there an ECU reset or otherwise? Cheers.
Did you make sure you didn't mix up the TPS and map connectors?
Yes, because I had to calibrate the TPS correctly connected. Great point.
@@KevinKarlStudio not really any "reset". You can disconnect the battery and it will reset everything though. Did you make sure it getting spark? And is your fuel pump priming?
@@hondaresource After checking out some other things this morning I disconnected the MAP sensor... and it started. I guess it was time. Replaced and good to go.
And BTW... Listening for the fuel pump spin up and checking for spark/ fuel pressure were on the short list this morning. Cheers.
Will this tps adjust work on 1999 CRV? Thanks
Yessir, same process
Thanks for the video it was very helpful and I adjusted the TPS on our 99 CRV just now!
@@anthonytorres2237 glad it helped
What is this service for
Replacing the throttle position sensor.
HONDA!!!
PLEASE MAKE A SIMPLE MACHINE!!!!!!!!!!!!!!!!!!!
👊
What if its 4.5 at open thottle but 0.83 at closed