Replacing My Old LED Headlight Bulbs With New Fahren LEDs
HTML-код
- Опубликовано: 11 сен 2021
- In this video, I take out my old LED headlight bulbs and replace them with newer and brighter LEDs.
Products used in this video:
Fahren H11/H9/H8 LED Headlight Bulbs: amzn.to/3kbuEXL
Dust Covers Shown - amzn.to/3kisnd6
Previous LED Installation Video : • Auxbeam LED Headlight ...
*** Don't Forget To Subscribe ***
Mike's House Of Mods Merch - www.mikeshouseofmods.com
Products used In My Turbo Build:
Klean Strip Paint Stripper - www.homedepot.com/p/Klean-Str...
Rust-Oleum Paint - amzn.to/2wvl3ES
AEM Boost Gauge - amzn.to/2UPJl66
AEM Wide Band Air-Fuel Gauge - amzn.to/2XgxCz8
Hose Heat Shield - amzn.to/3c84COf
Water Pump - amzn.to/2WhPWau
Coolant Pressure Test Kit - amzn.to/33rQCf5
Turbo Heat Shield - amzn.to/2IUXR5E
Power Steering Relocation Kit - tinyurl.com/powersteeringrelo...
Check out the turbo installation day 1 video - • Installing A Turbo In ...
Check out the turbo installation day 2 video - • Saturn Sky 2.4L Turbo ... hj
Check out the turbo installation day 3 video - • Saturn Sky 2.4L Turbo ...
Check out the turbo installation day 4 video -
www.youtube.com/watch?v=rbdcY...
Check out the turbo installation day 5-6 video - www.youtube.com/watch?v=-Ar4i...
Check out the turbo installation day 7 video - • Saturn Sky Ecotec 2.4L...
Check out my new website - www.MikesHouseOfMods.com
Disclaimer:
Due to factors beyond the control of Mike's House of Mods, I cannot guarantee against improper use or unauthorized modifications of this information. Mike Martin assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Mike's House of Mods recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Mike Martin, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Mike Martin. Авто/Мото
I have the same ones. 2 years running strong. Fahren makes some quality bulbs. One thing is people forget to adjust their projector housings. VOL and VOR is the first thing to figure out. Then do the 25 foot rule, and 2" below the center of housing.
Hi Mike, I did ALL of your LED light upgrades, what a difference, thank you and great videos
Had my 2007 Sky (base model) for a week now. I’ve been shopping for 2 months and been binge watching your channel and getting some great ideas and how too’s on mods and upgrades.
Used you links to purchase bulbs, dust boots and car seat gap fillers.
Keep doing what you’re doing, you are helping group of folks that need this info.
Great video. Fahren makes a very good light. Lumens usually works with wattage of the LED bulbs which watt for watt are much brighter than halogen bulbs. Should aim them on a flat wall about 20’ in front and measure the height of the bulb (center of light housing ) to ground and put vertices tape on wall and mark height of bulb. Your top of low beam light pattern make about 1 to 2” lower than the center straight ahead light pattern. LED are great as long as there aligned correctly. Thanks
Your sky really looks great, thanks for making these helpful videos
Thanks so much!!!
Nice video Mike. Thanks for sharing.
Liked for the cat
Well done 🥇, fantastic light
Thank you for the video. Do you happen to know what was the distance when you first installed the old ones?
Haha the cat cameo. Thanks for doing a nice before/after with measuring.
Awesome video.
Another informative video sir, thank you.
Also the dog at the end, over your shoulder, 😂💩
Would my Solstice take the same number bulb?
Great video! Would you use for the high beams? What would you recommend for the fog lights?
Yes, I would...once my current ones go bad. I still have the old fog lights and rarely use them, though, since I have the switchback turn signals and they are bright white and on when the turn signal isn't.
Hi
You need to clock the LED’s at 9 & 3 a clock got best light output.
Thanks. That's what I did :)
I might have missed it, but where did you get the dust boot?
You can get them here. amzn.to/3kisnd6
Can you provide a link to where you ordered your turbo kit?
It isn't a kit. It was a custom setup from a local guy who had it on his Solstice 2.4.
What's the update they still run good
you can see at 11:02 that the beam is going up...
Thanks for the demo. Useful for once. Good lighting and sound. Next time, shave before .
Got LEDs headlights blubs in mine Pontiac g two doors. Got in mine headlights blubs and mine foglighs and switch back go yellow and white. Love LEDs and so much better than h.id. see more with LEDs. H.i.d .get hot and LEDs have fan on
Mike, I am brand new to the Kappa game...is there particular places that you buy parts or accessories?
Depending on what I need, I usually use Amazon or eBay. However, I've also purchased items from CarID.com
Iam looking for the dust boot also.
You can get them on Amazon here - amzn.to/3kisnd6
Kinda partial about the bulbs. IMO. In time, the fan housing will get dirt/dust accumulation. W
DONT DISS THE CAT
Mike, does the resistor get hot?
I haven't checked yet, but I will when I get a chance.
@@MikesHouseOfMods did you check?
@@carbajalf9835 it does get hot. Mike is running the risk of having it overheat and possibly melt the wiring he mounted it on. The zip ties should be holding onto the wires not the driver
You tested the lights in two different locations. The first looks like your facing up a hill and the second on the flat. Not a good test.
No. They were both on the same flat road at the same location.
At 11:17 they look different.
Fahren is a good reputable brand. Seen many great reviews on RUclips can’t go wrong lol