Видео

My 2014 hilux started retuning the radio presents to stations I never listen to, now it's stuck on videos, even though there's no camera connected, and the touch screen doesn't work, have tried to reset without any luck, really frustrating got no idea what to do.

There’s a lot wrong with this video when it comes to ‘doing it correctly’.

Four phones were working just fine on my 2015 Tacoma, then suddenly, for no known reason, my Bluetooth and phone greyed out. Then, no phone listed, so there was no way to delete anything. This reset of ignition in on, holding apps button, turning on an off light 3x with and hitting reset worked perfectly. Thank you.

Little tip. Chalk the wheels and put it in neutral. Then you can turn the drive haft by hand to get to the zurk fittings easier

This shit doesn’t work

Great!!! Thanks

is your Falken wildpeak tire is E load rainge?

Curious , rav 4 & highlanders of all years &models seem to still have braking issues ? Warped rotors , these are all done by Toyota mechanics, seems the rotors are too small & not thick enough or low quality metal ? & calipers are too small for these heavy vehicles? Any other brands work for these issues ?? Thanks !

You never had an issue with the lock nuts wearing down the plastic of the tank from vibration? That’s assuming the tank is resting on top of the lock nuts.

In most cases, Advics (Sumitomo) a division of Aisin manufactures Toyota's TFR Brake Pads. Available through Rock Auto and they always have a 5% off coupon. FYI, dealers markup on parts is about 40%, so ALWAYS haggle with them on their prices. NISSIN also makes OEM Japanese pads, and so does Akebono. Having tried them all over the course of almost 600,000 miles, I can say that the NISSIN and Advics are the best, the Akebono formula generates more dust and are harsher on the rotors.

Instead of those aftermarket brackets, how about 22inch bar would fit?

Take it back! That sounds like shit. 😮😂

what bike rack do you use , can you share ?

I had this problem with my 2016 4Runner. It shut and returned frequently, and I had no idea what to do. If I take it to the dealer, I cannot swallow the cost of fixing it. It will be way bigger than my neck.

AGM requirements for full duty charges are 14.83 volts, 4runner alternator is programed to stay less than 14 volts at max output until you change it. you will be ok but won't reach full charge. It could matter on AGM longevity benefits

I wanted to take a moment to say thank you for your time and discussion on this matter. I ran across your video after stripping out the 3/8's square on my 64 flute, cheap oil filter wrench. After a lot of frustration and failure after my initial attempt to open the oil filter housing and a trip or two to the auto parts store to buy similar inadequate oil filter wrenches, I took about a week to research this and saw your video. Having just successfully opened up the plastic oil filter housing, I employed the following strategies; I purchased the correct oil filter wrench and a 1 1/6" - 1/2" drive socket that had the flutes as well as the three prongs that slid over the 3 plastic nubs on the oil filter housing and used paper to make sure everything was snug, I made sure that the oil in the car was sufficiently warmed up by driving the vehicle, I purchased a couple different sized dead blow hammers to tap around the plastic part of the oil filter housing, and I tapped around the aluminum housing unit for about ten minutes using a long punch, and instead of using full force like I did last time and stripping out the oil filter wrench, I only used about 60% of my strength and slow and steadily used for force to open it up. Thank you again for sharing your knowledge and experience.

I purchased the cheaper Toyota pads. They actually say made in Japan. Replaced them myself with the supplied grease. No squeak whatsoever. Super happy I got my “cheaper” ones.

You don't have to pry anything. You should be able to push the tube down against the spring pressure and turn.

I had to go with the metal one because the last person screwed on the plastic housing so tight that i broke it unscrewing it. i did not switch over the tube. so far, no leaks.

Does this method resolve from freezing toyota bootup logo?

100 percent correct my 08 4Runner manual says you can use moly lithium chassis grease NLGI #2 OR lithium base multipurpose grease,NLGI NO.2 for the slide yoke AND FOR THE SPIDERS lithium based chassis grease NLGI NO.2 SO This grease along with many other brands covers both..it does not say to use moly grease on the spiders probably wouldn’t last as long

Any chance this works on the Tacoma 2014?

Thanks Jake!

Does anyone know if Toyota have a recall on this, because im getting frustrated?

The problem with my Fj is that the front calipers have been replaced three times. They keep getting seized up and only last about four to five years. I wish I would have known before I got my brakes done. I will ask for the better ones next time.

Does this work for 4th gen 4runner or just 5th gen ???

I got brakes that have AZ on them but read made in Japan.

I don’t understand why this is so popular to swap these out. Please tell me why, other than you like to piss away money for no reason.

You mentioned the light bar was a 42", any issues mounting it on the Prinsu rack? They say their cutout is meant for 40" and I've heard some people had to do some cutting

Great video, audio and info. I wonder how they work in icy conditions

Nice presentation.

The friction rating for those 60140 is EE. That’s two notches below GG, (Bosch, Akebonos ACP, power stop, etc) . What that mean is these have less “bite” than FF, GG or HH.

I just ordered the shifter. The stock one is awful.

Jake, I found this to be very helpful! Thank you. It worked on my '20 Corolla HV.

If I wanted someone to tell me who I should and should not vote for I would move to China, North Korea or Russia.

Terrible idea. The metal filter housing and the oil pan are dissimilar metals. They will corrode. Stick with the plastic housing.

Thank you so much for this❤️🫡

Neighbor had a 2 gallon roto out with the garbage,,,I grabbed when on my morning walk. Think he got frustrated with it and chucked it. Going to try your trick,,,thanks…..

Would love to get all the part numbers for that suspension but im guessing its not $600 anymore

Are you running a new dash cam? Any suggestions?

Thank you for this

What fog lights do you have ?

5th Generation 4Runner??....Much Mahalo 🤙

Camera focus is actually a thing.

What about my 2014 Camry that doesn't have an apps button?

I skipped on the “AZ” as those are the cheaper noisy ones …

California Air Resources Board (CARB) rule that banned the sale of traditional gas cans. Just one of many dumb things California does.

What rotors? Everything depends on match between rotors and pads…

Problem is that is Atari like resolution -it’s horrific

Are there 2 different types of Toyota rotors like these brakes or the rotors have only 1 kind Toyota brand?