If you or a mate have a flux core welder try building up some material and then grind down to fit. Could use stick or tig, but flux core would be easiest.
@@DryUrEyesM8 Hey mate thanks for commenting! I was wondering if you weld the shaft where it's worn do Think you cut the groove with a hacksaw for the e clip?
@@DryUrEyesM8 That stuff is tough I would be interested to see it holds up! I had another idea to cut the groove deeper and run a smaller e clip ? Seems like soft material for stainless to wear like that must have a fair amount of pressure on it.
If you or a mate have a flux core welder try building up some material and then grind down to fit. Could use stick or tig, but flux core would be easiest.
Could use JB Weld. I fixed a leaky garbage disposal ~3 years ago with JB Weld and it's still holding.
@@DryUrEyesM8 Hey mate thanks for commenting! I was wondering if you weld the shaft where it's worn do Think you cut the groove with a hacksaw for the e clip?
@@DryUrEyesM8 That stuff is tough I would be interested to see it holds up! I had another idea to cut the groove deeper and run a smaller e clip ? Seems like soft material for stainless to wear like that must have a fair amount of pressure on it.