Do you know if there is a way to tell my F30 that I totally switched my DPF to a new one so the sensor doesn't throw the error all the time of 245700 and reduce my performance ? I haven't siwtched it yet but I can't find the option to reset the state in the BimmerLink or BimmerCode thing
Thank you for the video. Can you explain how to navigate to perform this test in Ista+? I recently also cleaned my filter on 2014 328d and wonder if it was all in vain..
thanks for your video. What did you use to clean your sensors? how it should be done? I dont want to damage them many thanks and await your reply please
After the sensors were removed, they were cleaned with a wire brush and then washed with brake spray. Be very careful with the electric wires so they don't break.
Some services use anti-tartar solutions for bathrooms, I sent this filter to a company that deals with professional cleaning, from what I understood it was heated to 600 degrees Celsius, then the cleaning takes place with a certain substance, I don't know more, but the results are OK so far now.
37mbar is way toooo much! My e90 325d 197hp had 4mbar backpressure on idle after 300_000km. Stil a lot but man these 2liter n47 b47 are soo restricted even if the dpf is new it still has like 10mbar pressure on idle
Do you know if there is a way to tell my F30 that I totally switched my DPF to a new one so the sensor doesn't throw the error all the time of 245700 and reduce my performance ?
I haven't siwtched it yet but I can't find the option to reset the state in the BimmerLink or BimmerCode thing
Yes, a diagnosis can be made with ISTA where you can access the particle filter and reset it.
did you have to loosen up the exhaust pipe behind it. I cannot get the DPF out .
Thank you for the video. Can you explain how to navigate to perform this test in Ista+? I recently also cleaned my filter on 2014 328d and wonder if it was all in vain..
Watch this video ruclips.net/video/2SArn1oqaB4/видео.html
thanks for your video. What did you use to clean your sensors? how it should be done? I dont want to damage them
many thanks and await your reply please
After the sensors were removed, they were cleaned with a wire brush and then washed with brake spray.
Be very careful with the electric wires so they don't break.
thanks a lot...By the way when putting back do you have the torque specs for every bolt?
@@JHAMS.001-car-repair
torque specs for the sensors as well when putting them back????
@@igortanyarascovschi1225check ista. It will tell you torque specs
What did you use to clean the filter
Some services use anti-tartar solutions for bathrooms, I sent this filter to a company that deals with professional cleaning, from what I understood it was heated to 600 degrees Celsius, then the cleaning takes place with a certain substance, I don't know more, but the results are OK so far now.
Hello im looking to do this job to my dpf , but i see at the end of video you got doubled the value why?
37mbar is way toooo much! My e90 325d 197hp had 4mbar backpressure on idle after 300_000km. Stil a lot but man these 2liter n47 b47 are soo restricted even if the dpf is new it still has like 10mbar pressure on idle