Ас саламу алейкум всем! На табло постоянно горит vdc slip, много причин оказывается есть, с трудом находил всякие возможности исправить ошибку, как долить масло в гидрач или тормозную жидкость, за этим всем стараюсь следить,, в самом деле оказалось то, что полгода назад красил задний бампер, купил новые датчики парковки, соответственно их тоже красил,, в дождливую погоду поначалу беспрерывно пикало в салоне пока не выключишь кнопку парктроника, до сегодняшнего дня уже больше недели как не мыл машину,,помыл на мойке,,в итоге ошибка перестала появляться на табло... Отсюда итог-из-за повреждения датчиков парковки - это тоже может быть, так как я после покраски повредил датчик. Удачи всем и терпения!
Thank you so much brother. Vdc and slip light and break ligh was on on my g 35, 2006 cupe , it was low on brake fluid as you said, I add brake fluid now problem is fixed. thanks to you, I subscribe to your Channel.
Bro so I bought my g a few months ago and I had the lights on but shir was the can shaft sensor replaced it and also ended up replacing the fuel pump cause it was going out. Car runs fine now but at random ass times they lights turn on idk if it’s just a dummy light or not
Do you know what the red white and yellows for I know that's how you plug in like a old school super nintendo or nintendo sixty four, but does it use the car's screen or where is the video signal going to
Got slip and TCS off lights on. Engine light is on so I got the codes read and it came back with a faulty knock sensor, about to replace it but wondering if it could be anything else. Car doesn't go into limp mode and sounds and starts like it should. Car was left sitting for 4 years without being driven much and previous owner had to replace seized battery and starter
@@JLowe I topped off the steering fluid then reset the ecu and none of the lights came back on, usually they turn on after the car being driven a tiny bit but this time they didn't. I might not have driven it long enough or maybe all it needed was fluids topped off. Code is p0327.
Nevermind, lights came back on after starting it today. I've taken it to an auto electrician and they read the codes and it only came back with the knock sensor harness
Do you think that if something going on with my fuse box can make that turn on bc my 04 g35 started losing power for a quick sec the same way u said on the freeway and I made it off to a small street and now my car doesn't even turn on 😮💨
I owned 4 G coupes 05 rev up manual 2011 G37 IPL auto 2005 G35 auto Now a 2004 G35 auto All of them I've had to do this except the IPL I currently just changed ignition coil 6 and now I'm getting a slip and VDC light right after I changed the coil. And it's Givin me trouble starting...so I know these vq engines so well I know its going to be a camshaft sensor because I changed the crank shaft sensor recently which gave me the same issues if not vdc fuses maybe. And I'm dealing with code p1757
I have an 04 g35 coup. My problem is when i start the car no light comes on but when I step on the break to put it in drive the shifter won't shift an all the vdc slip an abs light comes on. I replace the break switch an still nothing. Any help would be appreciated
@@toxichazard6442 window motor is that bad to replace. The A/C is a little more difficult but still not super challenging. I’d try to fix those and sell it yourself versus selling it to a dealership, you’ll get more for it.
Ас саламу алейкум всем!
На табло постоянно горит vdc slip, много причин оказывается есть, с трудом находил всякие возможности исправить ошибку, как долить масло в гидрач или тормозную жидкость, за этим всем стараюсь следить,, в самом деле оказалось то, что полгода назад красил задний бампер, купил новые датчики парковки, соответственно их тоже красил,, в дождливую погоду поначалу беспрерывно пикало в салоне пока не выключишь кнопку парктроника, до сегодняшнего дня уже больше недели как не мыл машину,,помыл на мойке,,в итоге ошибка перестала появляться на табло...
Отсюда итог-из-за повреждения датчиков парковки - это тоже может быть, так как я после покраски повредил датчик.
Удачи всем и терпения!
Bro speaks so clearly makes it very easy to understand
Thank you so much brother. Vdc and slip light and break ligh was on on
my g 35, 2006 cupe , it was low on brake fluid as you said, I add brake fluid now problem is fixed. thanks to you, I subscribe to your Channel.
Glad I can help!
Bro your videos are very helpful fr. I have a DE and it’s been kicking my ass lol. When I get my g to 100% we gotta do some runs💯
Glad I can help big dawg! I’m always down to do a couple runs!
Thank you brother for your knowledge. God bless.
Excellent video, thanks for sharing and I hope you have a great day!
Hey, I appreciate it! I hope your day was great as well!
Bro so I bought my g a few months ago and I had the lights on but shir was the can shaft sensor replaced it and also ended up replacing the fuel pump cause it was going out. Car runs fine now but at random ass times they lights turn on idk if it’s just a dummy light or not
Did you use OEM sensors?
I saw another video where a guy used red and white with a headphone Jack based. It was like a cord, but I was wondering what people use the yellow for
My boii good looking out I forgot I was low on brake fluid I believe that’s the problem my light is on 😂🤙🏽🤙🏽 good man
which light was on?
Do you know what the red white and yellows for I know that's how you plug in like a old school super nintendo or nintendo sixty four, but does it use the car's screen or where is the video signal going to
Yes bro! I have 350gt skyline and my two 12 inch subs are on the back seat too! 👌👌🤣
No way!
@@JLowe it’s so loud! 😂
Got slip and TCS off lights on. Engine light is on so I got the codes read and it came back with a faulty knock sensor, about to replace it but wondering if it could be anything else. Car doesn't go into limp mode and sounds and starts like it should. Car was left sitting for 4 years without being driven much and previous owner had to replace seized battery and starter
What was the code if you don’t mind me asking? Have you topped off all the fluids?
@@JLowe I topped off the steering fluid then reset the ecu and none of the lights came back on, usually they turn on after the car being driven a tiny bit but this time they didn't. I might not have driven it long enough or maybe all it needed was fluids topped off. Code is p0327.
Nevermind, lights came back on after starting it today. I've taken it to an auto electrician and they read the codes and it only came back with the knock sensor harness
I have a few 03-4 M45s. Can u use that trick to kill the power on those also? Also having a hard time finding a posi unit for this platform.
Great video! Thank you so much!!!
Do you think that if something going on with my fuse box can make that turn on bc my 04 g35 started losing power for a quick sec the same way u said on the freeway and I made it off to a small street and now my car doesn't even turn on 😮💨
Same thing happened to me on my 05 g35
I owned 4 G coupes 05 rev up manual
2011 G37 IPL auto
2005 G35 auto
Now a 2004 G35 auto
All of them I've had to do this except the IPL
I currently just changed ignition coil 6 and now I'm getting a slip and VDC light right after I changed the coil. And it's Givin me trouble starting...so I know these vq engines so well I know its going to be a camshaft sensor because I changed the crank shaft sensor recently which gave me the same issues if not vdc fuses maybe. And I'm dealing with code p1757
That's a good sharp guy. A+
She started calling me at 4 this morning saying she was coming here bringing breakfast but never showed
I’m sorry to hear that. 🙏🏾
Wtf this got to do with the video?
🤣🤣🤣🤣🤣🤣🤣🤣🤣🤣🤣🤣🤣🤣
Thanks for sharing my friend. Watching from Indonesia and +1 new subscriber.
Appreciate the love! ✌🏽
Great video!
Awesome bro
I have an 04 g35 coup. My problem is when i start the car no light comes on but when I step on the break to put it in drive the shifter won't shift an all the vdc slip an abs light comes on. I replace the break switch an still nothing. Any help would be appreciated
Have you found a solution? I have the same exact problem
Try the neutral safety switch
Me and bro wearing the same sweater rn lmao
Bro I’ve taught myself so much trying to fix this issue bro, And I still have it
You and me both! I can almost disassemble the whole car
Have you found it yet
Is this the same on an automatic ?
Might test this with a vdc switch
What did you come in with?
Thank you bro
Thanks man!
What does the slip light actually mean ?
It can mean multiple things usually anything with a de vq in it, it’s a camshaft sensor
@@JLowe yeah I see that on mine
How many cam shaft senors do my 2007 g35x awd have
@@laquanlockhart3615 I think you have an hr engine so that would be 4 of them
Very handy bro
cam shaft port sensor 1
12 powers cuh 😂
Why does my slip light come on when I do a pull from being stopped?
Check all your fluids! Also I’ve read that when brakes are due they can trigger the light.
I have the vdc and slip light on and also my RPM gauge doesn’t work. Any suggestions?
Check for continuity for all the wires that play into the rpm gauge. That sounds like something electronic.
thank you! that slip light is pissin me off.
Did you get it fixed?
I was literally driving and they went away by it’s self
I just put new camshaft sensors not oem tho lol fucked me over
Not saying that they won’t work temporarily but they 100% won’t last long!
Selling my shi soon 😪
Why brother?
@@JLowe not willing to fix gotta spend like $2k I got 161k miles gonna finance a Q50
@@toxichazard6442 that’s not a bad move. What’s wrong with it?
@@JLowe crushed subframe window motors out A/C compressors out I had the Vdc break light problem to it just went away by its self
@@toxichazard6442 window motor is that bad to replace. The A/C is a little more difficult but still not super challenging. I’d try to fix those and sell it yourself versus selling it to a dealership, you’ll get more for it.
So if I disconnect it I can burn out
In theory. 😂
Yeah but if your driving fast and press your breaks u can slide
Is this code p0226?
It’s either P1084, P0345, P0340, P1078