Over Extrusion Problem | Material Flow Calibration in Cura | 3D Printing Tech Support

[@berlinberlin4246]

Please cut the music off!
The music is way too loud and the video in this form unwatchable!

[@m-printmanufacturing2017]

Thanks for the feedback and I’ll work on this for the next video.

[@BigChew03]

Maybe turn it down a little. I personally didnt mind the music at all. I think it was a good video, definitley not "unwatchable!" Good job on the vid

[@m-printmanufacturing2017]

Thanks for watching and providing some more insight. I can definitely adjust if it’s a bit too loud. Happy printing.