1978-2000 Ford C-II Power Steering Pump Rebuild
HTML-код
- Опубликовано: 5 авг 2024
- Quick and detailed walk-through of rebuilding my '87 F150 power steering pump using a Gates rebuild kit. This is NOT the Saginaw pump that people commonly swap on these trucks. If you have any questions/comments/concerns please ask them below!
Tools/Kits Used in Video:
Gates 351210 Power Steering Repair Kit
www.amazon.com/Gates-351210-P...
Maddox Pulley Remover and Installer Set
www.harborfreight.com/pulley-...
OEMTOOLS Pulley Puller/Installer
www.autozone.com/loan-a-tools...
Chapters:
00:00 Introduction
00:18 Input Shaft Seal Installation
01:35 Disk Spring Dowel Pin Installation
02:06 Lower Plate Installation
03:04 Cam and Slippers Installation
04:04 Upper Plate Installation
04:27 Valve Cover Installation
05:09 Retaining Ring Installation
05:58 Reservoir Installation
06:16 Flow Control Valve and Outlet Fitting Install
06:44 P.S. Installation into Bracket
07:12 Tools Needed for Pulley Installation
07:48 Pulley Installation
08:45 Outtro Авто/Мото
Nice job! straight talk and to the point! Thanks for posting!
Very well explained and detailed video!
Excellent videos on the tear down and rebuild. Curious though, is the c clamp a required tool or just makes it easier?
You need something to compress the assembly to clear the ring for the snap ring, C-clamp was the only tool I had to do so lol
So, good video. However, it looks like you didn't install the o-ring for the disk spring.
(Need to service a PS pump on an '85 Merc)
Are you referring to the one at 2:14? I added it to the lower plate, could go onto the pump housing too ontop of the disc spring. Manual showed installing them in the lower plate first so I followed it
Thanks. I missed that bit.