Is XVIVE U3 wireless XLR Still the Right Way to Go for your Mics and Speakers.
HTML-код
- Опубликовано: 17 окт 2024
- Xvive U3 Plug-on Microphone Wireless System Wireless XLR for Dynamic Microphone Audio Mixer, PA System, and DSLR Camera
Find up to date pricing on Amazon amzn.to/2YbVvKk
🎤-Wireless XLR transmitter and receiver, 2.4GHz band are optimal for Microphone wireless, Solid RF connection over a 90 feet range（normal）, uncompressed wireless signal transmission, low noise, and latency. Up to 107 dB signal-to-noise ratio provides clear, detailed audio at any volume. High-Resolution 24-bit/48kbps audio. Broad 20Hz-20KHz frequency response. Dynamic Range 107 dB.
🎤-The Xvive Audio U3 mic wireless system aims to take the complexity and frustration, out of traditional wireless microphone systems. Creating a flexible, all-in-one solution that makes any of your favorite microphones wireless, ensures good performance for your every show.
🎤-XLR transmitter and XLR receiver. Support 6 sets in the same place simultaneously. Works with any dynamic/Harmonic microphone, Audio mixer, PA system, Provides stable and reliable wireless transmission. Works with any active loudspeakers, Perfect for venues, weddings, and mobile DJs. Less than 4.5ms Latency（normal）, Simultaneous broadcasts on 6 channels.
🎤-The built-in lithium battery provides 5 Hours（normal） of battery lasts longer and a stable wireless technology (rechargeable battery for Transmitter & Receiver).
🎤-Order with confidence,30 days money back one year warranty,
expert island is an amazon affiliate and may be compensated by any link.
Thank you for this well-done review. Thinking about getting this device to plug into my mixer so that I can use my XLR mic from across the room without the cords. Very appreciative. :)
I have this and I can tell you that the Mic/Line switch is useless. If you're using this with powered speakers, as I do, the switch must be in the "mic" position, otherwise the sound will be very low. So, if you want your speaker to sound the same as if it were wired, use the "mic" switch. I contacted XVIVE about this issue and they also said, use the "mic" position.
Mic position start getting distortion after you start crank up your mixer.
how long does battery last and can they be charged at either end at same time as using them
I considered this device but chose to order a CARVIN WM5 which is on sale for $159 right now. Can't wait to try it out. Mic feedback though gives me a fit so am anxious about that!
Hi. Have you had the chance to compare these with something like the audio technica system 10 or other ‘proffesional’ wireless systems? I need 5 wireless connections for my family band, these seem the simplest straightforward solution, but I’m nervous if it’s reliable and natural sounding in comparing to systems from the big companies?
Great video. Would these interfere with wireless uplighters which are on 2.4ghz signal?
Can I transmit from opne transmitter to 3 different receivers simultaneously? (multiple-room PA setup)
hello sir I'm from Indonesia, I have a 2000 watt ALTO Ts 312 speaker but I got a problem with the 1st speaker breaking again,, how do I get the same Component speaker for ALTO Ts 312 .. please help,, thank you
I have bought two sets of these was a great buy
It can be plug, with an adapte XLR to TRS, into a mixer headphone jack, and use it as a transmiter to a Bluetooh headphone?
I mean, the transmiter can be seen by a bluetooh headphone?
Phantom power?
Can you add multiple receiver with one transmitter?
I hear a hiss when you used the wireless. Did the mixer gain need to be set hotter or is it in the wireless? Thanks for your videos.
Hiss is not likely from the U3s. Interference and too much distance sounds like the signal's breaking up.
Which would you recommend between these & the Alto product line?
I have several. I find to connect my mixer to my powered speakers it needs to be set to mic not line in order to get the same signal strength as I get with xlr cables
Hi Chris! So if you have 4 wireless microphones plugged into a mixer, how could you use these devices to transmit everything ( music and vocals from mics) to powered speakers? Or that is not how they work?
Thanks for any answers!
@@borg386 i use 2 instead of xlr cables to connect mains out on the mixer to the powered speakers. The other to connect the microphones to the mixer channels inputs. Hope that clarifies
I have a few of these and the line is so low in signal that it needs to be on mic the whole time
Great review, to the point. Thank u
How long can the sit between uses and do you leave them on the charger during storage
Around 6 hours then charge them for about 4 hours for a full charge. They should hold a charge for a year.
Can these be daisy chained to extend coverage to say 200 ft?
Can you please make a VS video with the Alto Ultimate?
Please we waiting for VS as I'm in between which one buy. thanks
Can it transmit to 2 receivers?
yes it can just place the receivers on the same channels.
Can they be charged at the same time as using them at both ends
Yes just make sure it is a good usb adaptor, some times you plug one in and you hear a humming sound changer then try a different USB adaptor.
@@expertisland ok I am worried about a 5g signal and 5g phones interfering with this signal in future and wish they had at least 8 hours battery time but if you can plug in and charge same time as using (both ends) this could be a perfect way to go wireless at long last. I am getting a few to try on your reccomendation.
Could I use a few of these in place of an alto stealth system? Plug a pair of them into ins and outs
These DO NOT LAST PAST 2 1/2 HOURS DEFINITELY NOT 3 OR MORE I HAVE FOUND OUT☹
IVE BEEN USING THEM AND ONLY ONCE DID I GET 4 HOURS
ONLY ONCE . I THOUGHT IT WAS MAYBE A DEFECT IN THE ONE I HAD BUT I HAVE SEVERAL OF THESE ALL THE SAME 👎🏽
does it work with mics that need phantom power?
You would get the U3C for 48v
@@expertisland Thanks
any hissing noise?
No Hiss to really make note of.
@@expertisland i literally hear hissing noise with nux, and at the end of the video, when you switched back to cable the noise was gone.
Not ready to pay 200 dollars for this sh-- there are some others for 100 bucks, those are the one that need to be tested and review. thank you, as always.
This review is nonsense! They have no where near a 90 foot range. It's like you've never used them and just read the manual. You are safe to about 15 or maybe 20 feet, then it becomes dicey. You really need an unblocked path. Anything stone (bricks, large rocks and even trees) will completely block the signal. Also no other 2.4GHz in the area - very hard to enforce.
In optimal conditions, the sound is perfect since they are digital. Optimal conditions will NOT be your normal.
hello sir I'm from Indonesia, I have a 2000 watt ALTO Ts 312 speaker but I got a problem with the 1st speaker breaking again,, how do I get the same Component speaker for ALTO Ts 312 .. please help,, thank you
Go to inmusic website they are all around the world and can help you with your speaker.