bodgit and leggit garage toyota corolla clutch part 3

bodgit and leggit garage
tips and tricks inside your video hopefully help you
don't forget get your hands dirty
A clutch is a mechanical device that engages and disengages the power transmission, especially from driving shaft to driven shaft.
Clutches are used whenever the transmission of power or motion must be controlled either in amount or over time (e.g., electric screwdrivers limit how much torque is transmitted through use of a clutch; clutches control whether automobiles transmit engine power to the wheels).
In the simplest application, clutches connect and disconnect two rotating shafts (drive shafts or line shafts). In these devices, one shaft is typically attached to an engine or other power unit (the driving member) while the other shaft (the driven member) provides output power for work. While typically the motions involved are rotary, linear clutches are also possible.
In a torque-controlled drill, for instance, one shaft is driven by a motor and the other drives a drill chuck. The clutch connects the two shafts so they may be locked together and spin at the same speed (engaged), locked together but spinning at different speeds (slipping), or unlocked and spinning at different speeds (disengaged).

[@SummisMontibus]

Thanks a lot ! This series of videos really helped me with my clutch replacement.

[@arthurwilkinson4059]

Good job

[@jacobluwai8107]

Well documented and highlighted step by step, highly recommended. thanks.

[@bodgitandleggitgarage]

thanks mate

[@TheSavageGarage]

Awesome video mate, i look forward to doing my first clutch job whenever mine decides to go!

[@zachdupaix2356]

An important note. If the flywheel is grooved, like when you wear the clutch plate into the rivets, the flywheel needs to be taken off and resurfaced at a machine shop or you will wear through the new clutch plate faster

[@scottaner500]

very good vid hop u don't stop making vids

[@kerrynball2734]

If you're planning to keep the car for long time after then I suggest new fork. I've had 2/3 fail after 280km. The other got to 400km OK

[@siucbset]

Great video, However: You are not supposed to breathe clutch dust.!.!.!

[@soldiersvejk2053]

Great video， very helpful！A small suggestion though: the dust is very nasty and harmful because it may contain asbestos. It's probably not such a good idea to blow it off.

[@bodgitandleggitgarage]

💪👍

[@ikecarney1383]

great vid. thank you for your time and effort to make it.

[@bodgitandleggitgarage]

Thanks mate and thanks for watching

[@stev21434]

hi like videos make the clutch feel very heavy when you're pushing Clutch pedal Clutch is not Slipping just heavy to push
Would do slave cylinder cause this problem thanks

[@hassemsadiq]

Awesome vid Doing this on the ground when lifting engine on oil pan with wood block will it not damage pan thanks

[@bodgitandleggitgarage]

hi mate I've lifted a lot of engines with wooden blocks underneath and never done any damage just like everything take your time and just make sure you will be fine

[@bradleyjones5932]

great vids , but couldn't see what you were lining up exactly ?

[@bodgitandleggitgarage]

Lining up the clutch plate in the middle of the clutch otherwise the gearbox will not fit back

[@sinfulkind]

Honorable mention of the man flu

[@sinfulkind]

don't blow the dust. No bueno mate!

[@bodgitandleggitgarage]

hahah

[@ikecarney1383]

found it

[@Bunnytoes666]

Thanks a ton. I figure that took you what....at least 6 hours altogether? My mom needs her clutch done and I'm just trying to estimate ROUGHLY how much time is needed plus a few hours in case Murphy pops his ugly little head out!