good shout I need to do calipers because the handbrake part keeps sticking, may as well do cable while I'm there. keep up the video's 👌 waiting for a CV driveshaft fixingz video 😂
No worries 👍 do the lot cable and caliper all sort then, 👍 drive shaft? Which part do you want to do? Can't take any more off the van he's now nearly down to a bare shell there's more in the back of it then on it 🤣🤣🤣
Cheers Mark for the heads up on the rear brakes, I've just overhauled the front end and the rear end is next ...so great video so i know what to look out for. Cheers Kev.
Hi kev No worries hope it some help, did forget to say about just unscrewing the Reservoir cap to let the air escape as the pistons are been pushed back in you'll probably know this doing the fronts anywhere 👍 Thanks for watching and subscribing 👍
Did mine few years ago, used the grinder to remove the stud heads then knocked them out, wasn't that bad of a job really key is to get the blow torch on the studs then knock them out, with the lower control arm supported so you can give them a good wack
Hi Mark, great informative video as usual. How would you go about getting that bearing nut off if it wont rattle off with a gun? Heard some right horror stories about them being F#@%ing tight and snapping 1/2" strongbars for fun & needing a 3/4 or 1" socket & bar, which i dont have!
Heat the nut up and then put some cold water on it straight way, and that will shock it. If you watch my video where I did my rear shockers, you will see how I did it, And thanks for the nice comment 👍
Hello Dear, I have already visited your RUclips channel. and analyzed the videos. Your videos are great & very nice but your video SEO and optimization are very low. This is a big problem. Because of this your video is not getting views, likes, comments, subscribers and is not viral going .Video uploading is very important for SEO and properly promotion. RUclips channels need SEO and video promotion. If you want, I can create a report on your channel growth . I am waiting for your response. Thank you
Авто/Мото
Love your videos. Really informative down to earth stuff. Fantastic
Hey cheers 👍👍, for that 😉
good shout I need to do calipers because the handbrake part keeps sticking, may as well do cable while I'm there. keep up the video's 👌 waiting for a CV driveshaft fixingz video 😂
No worries 👍 do the lot cable and caliper all sort then, 👍 drive shaft? Which part do you want to do?
Can't take any more off the van he's now nearly down to a bare shell there's more in the back of it then on it 🤣🤣🤣
Cheers Mark for the heads up on the rear brakes, I've just overhauled the front end and the rear end is next ...so great video so i know what to look out for.
Cheers Kev.
Hi kev
No worries hope it some help, did forget to say about just unscrewing the Reservoir cap to let the air escape as the pistons are been pushed back in you'll probably know this doing the fronts anywhere 👍
Thanks for watching and subscribing 👍
@@tinker-time Yes i undid the res cap when i did the front end, was going to say on your video you never showed that part lol
Do a vidbl of changing the front lower ball joints, there fun too do
awful job mate, have you just done yours?
do i 1.9 starter motor, total nightmare job, 🤦♂️
Did mine few years ago, used the grinder to remove the stud heads then knocked them out, wasn't that bad of a job really key is to get the blow torch on the studs then knock them out, with the lower control arm supported so you can give them a good wack
Hi Mark, great informative video as usual. How would you go about getting that bearing nut off if it wont rattle off with a gun? Heard some right horror stories about them being F#@%ing tight and snapping 1/2" strongbars for fun & needing a 3/4 or 1" socket & bar, which i dont have!
Heat the nut up and then put some cold water on it straight way, and that will shock it. If you watch my video where I did my rear shockers, you will see how I did it,
And thanks for the nice comment 👍
Hi Mark are you going to replace the back brake covers?
Yes mate, this side had it, other side ok 👍
How many Vivaro’s you got ?
3 at the minute, but another one hopeful is coming for the channel help people out 👍
Hello Dear,
I have already visited your RUclips channel. and analyzed the videos. Your videos are great & very nice but your video SEO and optimization are very low. This is a big problem. Because of this your video is not getting views, likes, comments, subscribers and is not viral going .Video uploading is very important for SEO and properly promotion.
RUclips channels need SEO and video promotion. If you want,
I can create a report on your channel growth .
I am waiting for your response.
Thank you