Hi bro... Really nice work... Can I suggest that you buy yourself some nice brushes... A set of nice mid range set of Tamiya or similar will cost very little... $25aprox for 3x brushes
Thanks mate. Looking into getting some decent thin brushes. These ones were cheap on ebay as you can tell. I had some nice ones in the past but over time the hairs kept falling out even when I cleaned them straight after use.
Good job. The 3d prints look good. How did you get the 3d parts to stick? I have trouble with normal superglue and have to hold it in place for an hour.
Thank you. I use Loctite, hold the parts in place and then sprinkle it with baking soda. It cures straight away. I put a few more drops around the joins and repeat with the baking soda. Hope that helps 🙂
Great Work
Thank You
Thank you so much
Hi bro... Really nice work... Can I suggest that you buy yourself some nice brushes... A set of nice mid range set of Tamiya or similar will cost very little... $25aprox for 3x brushes
Thanks mate. Looking into getting some decent thin brushes. These ones were cheap on ebay as you can tell. I had some nice ones in the past but over time the hairs kept falling out even when I cleaned them straight after use.
Good job. The 3d prints look good.
How did you get the 3d parts to stick? I have trouble with normal superglue and have to hold it in place for an hour.
Thank you. I use Loctite, hold the parts in place and then sprinkle it with baking soda. It cures straight away. I put a few more drops around the joins and repeat with the baking soda.
Hope that helps 🙂