How To Install Push Button Quick Release Car Bumper On Any Car
HTML-код
- Опубликовано: 7 авг 2020
- 2X Push Button Quick Release Hood Bonnet Pins Lock Clip Car Bumper Latch Kit EA
shorturl.at/jqz89
- - - - - - - - - - - - - - - - - - - -
Subscribe to my channel for constant uploads!
Connect with me
IG @nmbuilds
Where I Purchase My Cars:
IAAI: www.iaai.com/
Copart: www.copart.com/
Camera Equipment I Use:
IPhone X
Sony A6000
---
Disclaimer:
I take no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Thank You !!!
Good video of the installation and everything needed. I was wondering how you drill the hole on the bumper to line up with the push button bolt, now I know.
Tip... To avoid paint chips, when you start the spade bit, run it in reverse a few seconds, then go forward 👍
I've been wanting to do a really wacky car build and this kind panel locking will help. My goal is to attach the fenders and bumpers to ball and socket connectors that are actuated by electric motors so I can press a button and all my panels will just fall off of the car like the Blues Brothers movie. It'll be a mice gag for shows and I can just pop everything back in like Legos
Straight to the point and very clear just my video👌🏻
Very helpful. Thank you
Perfect instructions
Just about to do this on a Honda accord sport 2018 thank you 🙏
@nmbuilds, Did the screw drill through the fender(metal) too at
Gracias por la guía, me hacía falta
This was helpful. though you are a little off on your alignment.
Thanks for this. I suggest that you run a dry wall screw on the inside of the wheel well where the bumber is meeting the fender to correct the bumber flaring off. Awesome job though!
link for clips does not work...
What is that red paint to mark the drill hole?
Nice how to, but the fit isn't any better than before. I want these fasteners for a consistent fit.
👍🏾👍🏾👍🏾👍🏾👍🏾 thx