I have been watching for several months now. NX was the CAD software we used in university and now I just use it for fun (3D printing, etc.) I must say, your videos have completely revolutionized the way I design using NX. We focused mostly on solid modelling and a little bit of advanced simulation in school but we never touched surface modelling. Thank you very much, I appreciate every video you have made
Hello and thanks.I'm almost beginner in CATIA and it seems to me getting close enough through control points is very time consuming if not impossible!may you please speak a little bit about this(or will be great if do an example to acceptable tolerance although I know you're busy),I've checked your other videos which all are great but the question for me is "spending how much time through control points is reasonable?" and that "where and how helpful are the commands that fit surfaces,like "power-fit" or "automatic-surface" or "surfaces-network" or "fit-to-geometry"? thanks again for all your great great videos. it will be very very helpful if you answer.
Hi! Thanks for an interesting video! Were there a reason for extending the surface past the center line of the vehicle? Isn't it possible to use X-form as one would want with just doing one side and then mirror it? (While making sure surface continuity towards the center is maintained as one wishes)
I have been watching for several months now. NX was the CAD software we used in university and now I just use it for fun (3D printing, etc.) I must say, your videos have completely revolutionized the way I design using NX. We focused mostly on solid modelling and a little bit of advanced simulation in school but we never touched surface modelling. Thank you very much, I appreciate every video you have made
Now that is what I like to hear.
Thanks.
that real-time update setting was GLORIOUS
Thank you for your time
Please we need more detailing tutorials for reverse engineering from scan to 3d modling using NX 12
BEST REGARDS MY FRIEND
Great video, really helpful. Thanks for the time you put into making these videos.
Hello and thanks.I'm almost beginner in CATIA and it seems to me getting close enough through control points is very time consuming if not impossible!may you please speak a little bit about this(or will be great if do an example to acceptable tolerance although I know you're busy),I've checked your other videos which all are great but the question for me is "spending how much time through control points is reasonable?" and that "where and how helpful are the commands that fit surfaces,like "power-fit" or "automatic-surface" or "surfaces-network" or "fit-to-geometry"?
thanks again for all your great great videos.
it will be very very helpful if you answer.
Dear respected sir, please can you send me a video spline curve which is possible or not according to auto tangency by curve spline points(comb)
nice!
Hi! Thanks for an interesting video!
Were there a reason for extending the surface past the center line of the vehicle? Isn't it possible to use X-form as one would want with just doing one side and then mirror it? (While making sure surface continuity towards the center is maintained as one wishes)
Have a look at my most recent video. I will be doing more on this subject.
Thanks for the question.