I wanted these before but the people on fb that ordered them was showing the comparison of the bushings of when they first got them to three months down the line and they were worn to crap hopefully these are improved I love American Muscle keep up the good work.❤
Bought these 7 yrs ago, & put 50K miles on them, w many hard launches in there over the years. Then the dreaded clunk in the back end started. Sure enuff, the bushings had gone off. There Are no replacements or alternative bushings available for these, or AM doesn't offer them, so had to order another full set & replace them. I don't like how the bushings leave a gap between them when inserted into the arms. anything more than 1/2 inch, in my mind, is too much. The sleeve should be fully supported/surrounded by the rubber/plastic, in my mind. They come w a small bit of lube, & it's barely enuff to get the job done, but in this vid, it doesn't mention what type of lube they use. Various lubes aren't good for rubbers or plastic stuff. Otherwise, it firmed up the back end again. May want to replace the bushings in the axle tabs while you're at it for a the full stiffy feeling.
This install video fails to mention the different bushings sizes, different bolt guide sizes and now im hearing people in the comments say there bushings need to be replaced after low mileage I would stay away from this product!
![GEEK TIMË [OFFICIAL AUDIO]](http://i.ytimg.com/vi/ry-6RvkH880/mqdefault.jpg)
Shop These Tubular Control Arm ! : muscle.am/3vcjjhV
I wanted these before but the people on fb that ordered them was showing the comparison of the bushings of when they first got them to three months down the line and they were worn to crap hopefully these are improved I love American Muscle keep up the good work.❤
So wait.... The rear sway bar now mounts on the outside of the control arms?
Bought these 7 yrs ago, & put 50K miles on them, w many hard launches in there over the years. Then the dreaded clunk in the back end started. Sure enuff, the bushings had gone off. There Are no replacements or alternative bushings available for these, or AM doesn't offer them, so had to order another full set & replace them. I don't like how the bushings leave a gap between them when inserted into the arms. anything more than 1/2 inch, in my mind, is too much. The sleeve should be fully supported/surrounded by the rubber/plastic, in my mind. They come w a small bit of lube, & it's barely enuff to get the job done, but in this vid, it doesn't mention what type of lube they use. Various lubes aren't good for rubbers or plastic stuff.
Otherwise, it firmed up the back end again. May want to replace the bushings in the axle tabs while you're at it for a the full stiffy feeling.
This install video fails to mention the different bushings sizes, different bolt guide sizes and now im hearing people in the comments say there bushings need to be replaced after low mileage I would stay away from this product!