Saving a superstroke using the v groove.

Поделиться
HTML-код
  • Опубликовано: 21 ноя 2024

Комментарии •

  • @bwg8861
    @bwg8861 8 лет назад +2

    Thank you for sharing and also for wearing the apron.

  • @dessertman1181
    @dessertman1181 3 года назад +2

    Diggin the shorts thanks for the info

  • @BADD1ONE
    @BADD1ONE 6 лет назад +5

    I replaced my shafts with graphite. Wanted my grips. They were in great condition. I didn't want to spend 35$ for this tool. But I had a brick layers tuck pointer. A little shorter but with solvent it worked perfectly

    • @Chris_the_golf_guy
      @Chris_the_golf_guy  2 года назад

      I’ve been known to use a coat hanger as well. Plenty of ways to get there but this baby was well worth the $$ in its durability and savings on my back 😀

  • @MarvinofMars
    @MarvinofMars 2 года назад +2

    I did this with a Brick layers 8 inch pointing tool it does work, I took a superstroke 5.0grip off one putter and placed onto another , result. 👍👍

  • @mikec4229
    @mikec4229 4 года назад +2

    Wire coat hanger worked for me. Put some muscle into it. Took 10 mins

  • @weathp
    @weathp 7 месяцев назад

    Excellent video.

  • @imperfectlyresilient
    @imperfectlyresilient 4 года назад

    Thanks for the helpful video! I just got a similar tool and am looking to remove one of the newer Traxion SS grips.

  • @jessehodgesgolf
    @jessehodgesgolf 3 года назад +2

    The face at the end was the best part. Haha 😂

    • @Chris_the_golf_guy
      @Chris_the_golf_guy  2 года назад

      Yea I’m not the prettiest at the ball, but I can dance. 🥸 hopefully as I get to do more of these videos I’ll find my “you’re on camera, dummy” face.

  • @jimbeaver27
    @jimbeaver27 4 года назад

    thanks, I tried to get one on my chipping iron and failed half way, now it has to come off but it is very tight - at least now I know it can be done but I will try air first

  • @Barney29508
    @Barney29508 2 года назад

    I need to remove a Ping Man standard grip from a putter so that I can cut the shaft down an inch.
    I want to use the same grip when replacing.
    I don't want to damage the grip as they aren't cheap.
    How do I do that?

    • @Chris_the_golf_guy
      @Chris_the_golf_guy  2 года назад

      The ping man standard grip is rubber so this should work just the same but be a lot easier with no damage. If the grip is old and a little bit hard, a solvent injector would work better to loosen the grip and pop it right off.

  • @amadan34
    @amadan34 7 лет назад

    where do I buy this tool in Europe Ireland)?

  • @Voyager1649
    @Voyager1649 2 года назад

    The brush you used is that a special brush or it's just a average bottle brush?

    • @Chris_the_golf_guy
      @Chris_the_golf_guy  2 года назад

      The one to remove the tape is a special wire brush. They are sold at Golfworks.com and really help on stubborn jobs.

  • @rookie365
    @rookie365 3 года назад

    Link for the tool?