Xiegu G90 Back from the Dead - Fixed

Had a problem with the Xiegu G90 not powering up after being used on data modes. Turns out it had lost the firmware from the display unit.
Xiegu downloads:
xiegu.eu/downloads/
Tera Term download:
github.com/TeraTermProject/te...

[@HamTechRadioScannerDrones]

Nice clear Video Ben

[@m7frs272]

Thanks Andreas! 👍

[@richardbaker8928]

When I reflash I always do main unit first then the display unit that way you know you have a full re-install

[@ronwade2206]

Nice unit, 73s from KD7CKT Flagstaff. Just getting back on the air after 5 years of no gear at all, limited resources you know. Yeasu FT-60 from the pawn shop, still got no HF gear at all.

[@m7frs272]

Thanks for watching, welcome back to Ham radio!

[@PatrikS57AP]

Hi there nice vid! But mine has the same problem, but it doesn't go into FW update mode. Can you help maybe?

[@m7frs272]

Have you checked:
a) correct com port
b) correct board speed
Also: The timing of pressing the space bar after powering up the radio is critical. You may need to attempt this many times. Also, ensure that the radio is disconnected from the power supply after each attempt. Hope you manage to sort it. Thanks for watching 👍