As a Abarth owner and fan, I follow a lot of RUclips sites, this by far is the best tutorial for rear shocks I have seen! U saved me a bucket of money man!!! Since I did not know I was gonna fork over cash to the stealership, before I learned from u. Thx very much!
Don't forget to tighten the shock mount bolts with the car on the ground or the rear swing beam in the position it will be in at rest. Failure to do so means the rubber bushes will be stretched at rest and even more so on compression of rear suspension which leads to tearing and early failure. Nice car though!
Hi there, nice video, I have to do the same to my one, just wondering, is it necessary to take both out, drop the axle, then put the shocks back on, reason I ask is because I don't want to mess with the springs, so I was planning to do one side then the other, without dropping the whole axle, possible you think? Cheers
As a Abarth owner and fan, I follow a lot of RUclips sites, this by far is the best tutorial for rear shocks I have seen! U saved me a bucket of money man!!! Since I did not know I was gonna fork over cash to the stealership, before I learned from u. Thx very much!
Don't forget to tighten the shock mount bolts with the car on the ground or the rear swing beam in the position it will be in at rest. Failure to do so means the rubber bushes will be stretched at rest and even more so on compression of rear suspension which leads to tearing and early failure. Nice car though!
Thanks for the video. Did you changed or cut the bumper stop? And are these the pro kit eibach? I got the same set up not yet installed
Pull down on tne shock to line up and fit the bolt in tne left one...
Thanks for posting Very helpful video.
Hi there, nice video, I have to do the same to my one, just wondering, is it necessary to take both out, drop the axle, then put the shocks back on, reason I ask is because I don't want to mess with the springs, so I was planning to do one side then the other, without dropping the whole axle, possible you think? Cheers
Why did you disconnect one end of the torsion bar?
Very clear. Thanks
Nice vid. Looks super easy. Thanks
Why the 1st springs had the part with the closest turns side down and the new ones not?
Could you tell a difference with the Koni’s vs. Stock?
The rear shock is a 15mm bolt.Thats because it's metric and not 5/8.Fiat made in Italy =Metric.😂