2020 newer Escape Sunroof and Shade Initialization

Поделиться
HTML-код
  • Опубликовано: 4 фев 2025

Комментарии • 23

  • @Emiliow907
    @Emiliow907 Год назад +1

    Great informative videos as always, I’ve got 2018 f150 with the panoramic sunroof and the tabs/brackets for the shade broke off any idea if it can be replaced separately or what I need exactly? thanks a lot

    • @SealofPerfection
      @SealofPerfection  Год назад +1

      If you're talking about the 2 mounts for the shade where the metal bar attaches and they pull the shade back and forth, the only way they come is with a new track. Not available separately that I've ever seen. You'd have to disassemble the track itself to put them in if they did.

  • @dogman9822
    @dogman9822 Год назад +1

    Great video with mine after doing the procedure with the shade after pressing the back button it goes bavk an inch amd will not go any further can you help me with this?

    • @SealofPerfection
      @SealofPerfection  Год назад

      Does it run through its full range of motion while you're doing the procedure?

    • @dogman9822
      @dogman9822 Год назад

      @@SealofPerfection yes it does

    • @SealofPerfection
      @SealofPerfection  Год назад +1

      @@dogman9822 well I am not 100% sure what is wrong. I just looked at a 2022 yesterday with kind of that similar issue. We are going to replace both the motors and the switch in that.
      I won't know if that is the problem until the parts come in though

  • @katelynnboyd9141
    @katelynnboyd9141 4 месяца назад

    I can't tell for sure based off these other comments descriptions.
    So our shade will open and close just fine but the fabric itself droops all the way down as the shade opens. The mechanics seem to be working just fine but the shade itself isnt tight and doesn't (what i assume) rolls into itself.
    I've tried looking at other videos and i found something that shows how to get to all the inner workings by basically taking off the trim and pulling it all out to expose the sunroof system 😬
    We just had our 2020 taken in to fix the overheating engine recall and asked for them to fix described sunroom problem and they quoted us $2800 to fix it?! Idk if it matters but we are in California bay area. Absolutely bonkers

    • @SealofPerfection
      @SealofPerfection  4 месяца назад

      @@katelynnboyd9141 there's a good bit of Labor involved. You need your shade replaced most likely. It's not uncommon. I just did one last week

    • @katelynnboyd9141
      @katelynnboyd9141 4 месяца назад

      @@SealofPerfection I thought I replied to this but I guess it didn't post. Is this something my husband and I could attempt together? Or are we just SOL unless we pay the dealership two months rent 😅 my daughter loved the panoramic roof and she's been asking when we are gonna fix it 😔

    • @SealofPerfection
      @SealofPerfection  4 месяца назад

      @@katelynnboyd9141 They are a huge pain, IMO.
      I don't have a video on it yet. Not sure if I ever will. I'd need someone else to film.
      I'm not sure I'd want the dealership doing it, unless they have someone who has done a couple already. Not for the faint of heart, not the first couple of times, anyway.
      Sorry but that's how I feel about them.
      I can do them pretty well now, but those first couple were SUPER "not fun".

  • @Matthieuwil
    @Matthieuwil 2 месяца назад

    Did you have to remove the headliner to install the new sunroof shade? Or were you able to install the shade from removing the sunroof glass? My shade cover is drooping. I’m assuming the sides came off track.

    • @SealofPerfection
      @SealofPerfection  2 месяца назад +1

      Dropped it from about the rear grab handles back. You have to to get at the 8mm nuts that hold the shade to the roof

  • @straycaatstrut
    @straycaatstrut Год назад

    What if the sunshade is off track but it’s not ripped or anything but it was because of that molding that fell off? Is it fixable ?

    • @SealofPerfection
      @SealofPerfection  Год назад

      Hard to say without seeing it. If the sides that hook under the tab that keep them tight are not messed up then it could possibly be put back in place, but they fit into a little slot and if they are messed up at all or mangled, it will probably need to be replaced.

  • @davidfenderson7299
    @davidfenderson7299 Год назад

    Test drove a 2020 today. It has EXACTLY what you described in that it bunches up at the back. How did you fix that? And did it just jump off the track, spring broke, or ? Please let me know. Thanks!

    • @SealofPerfection
      @SealofPerfection  Год назад

      Replace the shade. It's not a fun job. I think it just came loose on the side, but a couple I've seen were caused by the plastic molding falling off

  • @spencertechgaming
    @spencertechgaming 8 месяцев назад

    So my shade moves back fine and all but the front half has just come out of the track, is there no way to slide it back into the track? It’s just the sides in the middle

    • @SealofPerfection
      @SealofPerfection  8 месяцев назад

      Probably not. I have had to replace a few of these for that reason and usually once they come out they are not very salvageable.

    • @spencertechgaming
      @spencertechgaming 8 месяцев назад

      @@SealofPerfection well dang, how much are they to replace? I just got the car a couple days ago and it’s come out, could I source the part from somewhere?

    • @SealofPerfection
      @SealofPerfection  8 месяцев назад +1

      @@spencertechgaming as far as I know you can only get them from the dealer or Ford authorized parts distributors. There are some online such as Ford parts Giant

    • @spencertechgaming
      @spencertechgaming 8 месяцев назад

      @@SealofPerfection is it possible to replace on my own. I do have the technical skill to do it, just need to know how difficult it would be. I’ve replaced things under the hood but never the inside

    • @SealofPerfection
      @SealofPerfection  8 месяцев назад

      @@spencertechgaming they are not very pleasant to do. I have not made a video on one because I have not felt like it was something the average DIYer might want to tackle. Nor do I have a good enough handle on my process for doing it to explain to people. If you're really good with cars and tools then you probably can do it, but it is not fun at all I can just tell you that. I hate to be that vague, but it's just not an easy one.