Where Has ECOstruder Been? Check Out The New Shop!

It has been a while...so where has Brandon been? What's new? And what does the new HartSmart Products shop look like?
Are you in the Des Moines area? Come visit the shop!
9103 Swanson Blvd.
Clive, IA 50325
[e-mail]
www.HartSmartProducts.com
Follow ECOstruder on Social Media:
/ ecostruder
/ hartsmartprod
/ ecostruder
Products Mentioned:
TreeD Pneumatique:
hartsmartprodu...
DynaPurge Cleaning Filament:
hartsmartprodu...
3D Fuel Materials:
hartsmartprodu...
Taulman3D Materials:
hartsmartprodu...
Taz Enclosure Design:
www.thingivers...

[@lyoder]

Good luck with your lab! I was in Des Moines for Thanksgiving last week - I should have stopped by. I'm considering buying a Modix big 60 to prototype body panels for agricultural machinery.

[@ecostruder]

Thanks Luke! Yes, I would have loved to talk to you about it. Sorry it didn't happen while you were here, but feel free to reach out via email to [e-mail].

[@MichaelFidler1]

Nice setup... lots of potential! I finally got our Big-60 running - just printed out my first benchy! Looking forward to the video about your mods that you made to yours. Did you add some gcode for a purge/wipe before starting the prints? I found that it didn't really start printing well until after the first layer.

[@ecostruder]

Thanks, and congratulations on getting your Big60 up and running! Yes, I always use a skirt. Usually about 3 outlines on the skirt, and typically about 4-5mm offset from the main part itself. That helps a lot to get things flowing properly before starting to print the actual part itself. Hopefully that helps!