How to REPLACE a window regulator (04 Boxster 986)
HTML-код
- Опубликовано: 7 фев 2025
- How to replace a passenger side window regulator on a 2004, 2003, or possibly earlier Porsche Boxster 986.
To see the door panel disassembly, watch the previous video:
• How to FIX / REPAIR a ...
DISCLAIMER: Lonely Ryder is NOT a professional mechanic and is NOT responsible for any injury or vehicle damage that may result from individuals attempting the repairs shown in this video!
You have been warned, try at your own risk!
Links (These fit an 04 Boxster, make sure it fits your specific year & model)
PASSENGER SIDE regulator:
www.autozone.c...
DRIVER SIDE regulator:
www.autozone.c...
Outro Music: "Demon" by JVNA (RUclips Audio Library)
Thanks for the video. Took me 4-5 hours but I got it done. I had an extra screw beneath the airbag sign in the door panel on my 2003. Also, it was much easier to roll the regulator to the down position and then fit the glass because you can see clearly without trying to peer in from the top if it’s in the up position. I was able to loosen just one airbag housing bolt a bit and slide in a new zip tie
An absolutely fantastic video. Thanks for taking the time to make it. Took me 120 mins rather than the 90 minutes the Porsche dealer told me it took last time. I had the window down to fit it into the clamps. Fiddly but relatively easy thanks to you. I took the airbag off briefly without disconnecting it electrically.
Glad it helped!
Great video and clear instructions. I worked well with my Boxster 986 '97, no need to disconnect the battery because it does not have the air bag. But note that it will be best to chase the threads of the plate on the new regulator that attaches to the motor before install, otherwise it is very difficult to thread the bolts. It took me a bit more than an hour to complete the install. Thank you!!!
Glad it helped
This morning I watched this video so I could fix mine after work. Thanks a lot! Took me and my buddy around 70minutes. Again thanks a lot!
No problem!
Thanks man, this helped me with my 987... basically the same, but no twist tie, and the motor is mounted on the opposite side of the door panel (under the trim)
No problem, glad it helped!
Grazie al tuo perfetto e dettagliato video sono riuscito a sostituire con facilità e precisione l'alzacristalli della mia Porsche Boxter. 👍
Grazie ancora. 🙂
Prego!
Great video thank you.The last step before reassembly you adjusted the height with the front clamp.Does the rear clamp have the same adjustment screw?
Both clamps have an adjustment screw, and I adjusted both of them, but I only showed one on camera for demonstration purposes.
@@lonelyryder7441 thanks for the response much appreciated
Great video, wish I watched it before I got started. My wife had snapped so I had zero window movement could just hear grinding from the motor. So I manually pulled the window up to enable myself to loosen the clamps. I have the new regulator installed but the motor doesn’t bring the window fully up and it brings the window too far down to the point where it comes off the runners. Any idea how I can sort this? I’m assuming I need to take it all out again? Thanks
Run the window up as far as it will go, then keep pressing the up button to try to get it to go the rest of the way up into roof seal. If you can get it all the way up, then let go of the up button and with one motion press and HOLD the up button for about 10 seconds. This should reprogram the motor to the new range of motion of the window. Then try to operate the window normally.
Great video, the hand thing has to go bro, very distracting from a viewing standpoint. Great information!