✅Fuel system Common Rail problem solved Nissan Navara 2.5 TDI! Click Subscribe❗

Поделиться
HTML-код
  • Опубликовано: 6 окт 2018
  • ✅ 📩ChipTuning file service! 📨modrix@inbox.lv
    ✅ 📞+371 29919194 📲WhatsApp,
    ✅ Skype ➡️ Modrix
    ✅ Прошивки для чип тюнинг
  • Авто/МотоАвто/Мото

Комментарии • 66

  • @pipww
    @pipww 2 года назад

    Awesome video thank you. Great advice also.

  • @amantikumera3496
    @amantikumera3496 2 года назад +1

    You did it. Tank U very much 👍👍👍

  • @sonnyponcian3913
    @sonnyponcian3913 3 года назад

    I have nissan naavara d40, my problem is that after traveling for almost 40k my truck begins to lost power and emit black. I have cleaned fuel tank, change fuel filters but still the problem exist..thanks for any advice...

  • @jnep9756
    @jnep9756 4 года назад +1

    Hi, near the SCV is a wire connection , what sensor is there , i have the connection but is not connected to anything

  • @stanleethustler6030
    @stanleethustler6030 3 года назад

    Thank you

  • @TK42138
    @TK42138 5 лет назад +1

    Good advice.

  • @markthompson1134
    @markthompson1134 3 года назад

    my nissian x trail is not starting its coming up low rail pressure could this be the problem

  • @pedritoblanco1364
    @pedritoblanco1364 Год назад

    That's what my Nissan navara problem is

  • @kw4690
    @kw4690 4 года назад +1

    I got my scv of ebay for 35usd. In 2018.

  • @claytonragbir2595
    @claytonragbir2595 4 года назад +4

    Clean fuel tank☺

  • @josephnganga804
    @josephnganga804 2 года назад +2

    My np300 yd25 engine will get a little bit stuck on rev 900-1100 and rev slow and after that it will do perfectly... When driving when going over a bump and the rev goes below 1 especially on gear 2&3 it will rattle also when when loaded on a small hill it will rev down and will turn off forcing me to use 4wheel drive high what could be the cause and how can I resolve it? Thank

    • @EvenFlow12345
      @EvenFlow12345 4 месяца назад

      Did you figure out the issue?

  • @westyorkshireengineservice9160
    @westyorkshireengineservice9160 4 года назад +2

    Good video buddy

    • @modrix
      @modrix  4 года назад

      Thanks a lot

    • @modrix
      @modrix  4 года назад

      Abas

  • @mpapadimonyela7508
    @mpapadimonyela7508 4 месяца назад

    Thank you. I was ready to throw away my car

  • @bignig2278
    @bignig2278 Год назад

    Why not show where the suction control valve is on the motor

  • @armandosejdiu917
    @armandosejdiu917 2 года назад +1

    Can i ask why my nissan navara sometimes dosnt go up to 3 abortail what is the prob i put a new injectors i changed the old one and again i have problem with power aometimwa goes good sometimes stops please help me

  • @rodneykufa352
    @rodneykufa352 3 года назад +1

    we a nissan np300 2.5. the vehicle has no power but if you switch off and on whilst the vehicle is in motion it will perform back to normal but the moment you brake the vehicle will loose power again. the diagnosis came and said the pump needs attention.

  • @promisemussa2355
    @promisemussa2355 4 года назад +4

    i have my nissan navara yd25 d40 it only cranking but not starting ,but if you do hard push it starts well.i took injectors for service and clean fuel tank but the problem still remains the same what might be the problem

    • @Emmanuelteina
      @Emmanuelteina Месяц назад

      Check your glow plug relay. Try direct heat and crank it

  • @shabibajwa9816
    @shabibajwa9816 3 года назад

    Hi guys, I have Navara d40,2010, we replace clutch and after that rev not go above the 3000. Attached the scan tool it’s shows code PO335, crankshaft position sensor ,any idea to solve this issue, please advise me. Thanks

    • @thelonewolf2181
      @thelonewolf2181 2 года назад +2

      There's is sensor on the gearbox just need to replaced it.

    • @shabibajwa9816
      @shabibajwa9816 Год назад +1

      @@thelonewolf2181 , you are the great. Changed the sensor and problem solved.🙏🙏

  • @mariamasalim9925
    @mariamasalim9925 4 года назад +2

    876 peugeot 206

  • @SCMode
    @SCMode 3 года назад +1

    hello, i replaced fuel flow control valve, remove fault with computer, but after test drive same fault occurred and same things happening, no power etc, where to check whats wrong?

  • @octaviantrutulescu3931
    @octaviantrutulescu3931 3 года назад +1

    hello i have an pathfinder 2006 also without DPF, i have no error on the tester but it does not make pressure on the intake, it has a very low vaccum pressure in the pipe that enters the selenoid sensor, i verified the pipes, there are ok, can you tell me what should i check next ?
    Thank you !

    • @modrix
      @modrix  3 года назад

      Vakum pump

  • @natiqibrahimov1766
    @natiqibrahimov1766 4 года назад +1

    Hello. I don't have a car speed. How can this be?

  • @HaysieBoy
    @HaysieBoy 4 года назад +4

    My 2009 Navara goes into limp mode when I set off quickly. It shows high pressure system fault code.
    Other than that there is very little power at low revs until 2500. Hill starts are nearly impossible. Once over 2500 revs it flys along no problem. Could this be a valve issue too??

    • @modrix
      @modrix  4 года назад +1

      Yes

    • @mohamedkhan1270
      @mohamedkhan1270 4 года назад

      Suction control valve by diesel pump, expensive but sorts the limp mode issue out

  • @mompatimase167
    @mompatimase167 5 лет назад +2

    Hey buddy. Where can i find that EGR cooler.

    • @modrix
      @modrix  5 лет назад

      Actually hard to say because I already forgot about this car so I can tell you perfectly I hope you will try and Google maybe find some picture thank you very much

    • @mompatimase167
      @mompatimase167 5 лет назад +1

      @@modrix I know what the cooler is.. mine has a hole in the heat exchanger and I just can't find one to buy, at a sensible price atleast. Nissan wants crazy money for it out here in Botswana ($1,400).

    • @modrix
      @modrix  5 лет назад

      @@mompatimase167 yes I believe you once I try to buy in Nissan dealer cabin Fan motor and they said to me 500 euros but I both in China AliExpress for just 80 Euros

    • @mompatimase167
      @mompatimase167 5 лет назад

      @@modrix thanks very much I'll look it up on Aliexpress..

    • @ephraimnjoroge6157
      @ephraimnjoroge6157 5 лет назад +1

      @@modrix my care rev reach only 2000rev per min. Dpf had an error p2002 n i cleared that what else can i do pls. When i depress accelerator the rev read 2000 rev per min. Pls help. Somalia no engineers for nissan car. Am lucky i have little abt them

  • @TollyTolly
    @TollyTolly 4 года назад +1

    I can see a lot of different car with denso fuel system, have same problem
    Company's should refuse using their systems, they are crap

  • @KR7PT
    @KR7PT 4 года назад +5

    Only a matter of time before that Navaras timing chain snaps, why bother 😂

    • @Mr330d
      @Mr330d 3 года назад +2

      In fairness the chassis could snap in half before the timing chain

    • @SalimKhan-gk1fh
      @SalimKhan-gk1fh 3 года назад +2

      @@Mr330d I’m not sure what is worse, the chocolate engine Or rusting chassis’s ? And now mercedes use that shit!

    • @Mr330d
      @Mr330d 3 года назад +2

      @@SalimKhan-gk1fh Mercedes x class premium price for rubbish quality 😂 it’s like buying an A180d with Renault 1.5 Dci engine 🤮

    • @SalimKhan-gk1fh
      @SalimKhan-gk1fh 3 года назад +2

      @@Mr330d yes u are dead right, do u watch salvage rebuilds uk? When they stripped the Mercedes GLA I was shocked that it was Renault rubbish! I will stick to my Audi allroad loved them last 15 years!

  • @lukepaki7231
    @lukepaki7231 3 года назад +1

    Where that part go?

  • @petermatovolwa6446
    @petermatovolwa6446 3 года назад

    You're explaining to tech people. Try to explain to users

  • @modrix
    @modrix  4 года назад +1

    ruclips.net/video/SzcPm2Ydl58/видео.html

  • @matthewwalker6621
    @matthewwalker6621 Год назад

    $40 on ebay

  • @TheDesperato
    @TheDesperato 3 года назад +3

    Blah blah blah n even didnt show the doing job!

  • @LuckyBoy-eo7em
    @LuckyBoy-eo7em Год назад

    P

  • @lukepaki7231
    @lukepaki7231 3 года назад

    Like n sub yol

  • @_Alfa.Bravo_
    @_Alfa.Bravo_ Год назад

    I hate DENSO so much

  • @thomasadmiral3401
    @thomasadmiral3401 Год назад

    you don't show
    how did you take it apart??