Thank god I watched this. I had a panick attack that I needed to buy more parts before he said something was stuck in the box. The same thing happened to me lol.
Don't cancel this, very informative, I am working on the bronco stock length as well, what do you think if even possible the tarantula with rear steer?
have you used this axles? I have them but I can't use them with the 7kg servo because the servo touches the motor even with the stock trx4m touches, seems that probably only works with the 11kg
I am using the axles with a 7kg and the Injora Micro Brushless MBL32 ESC & 1721 Purple Viper Motor. I have NO problems. You can try a INJORA MB100-R80 Brushed Mini ESC 20A if you are running a brushed setup, that should STOP the touches. ( NOTE: touches usually occur from lack of power from Traxxas ECM. )
nice review. exactly what i was looking for. the build quaility of injora is impressive
Very good info. Thank you for taking the time to show these parts in detail.
Happy to help
Thank god I watched this. I had a panick attack that I needed to buy more parts before he said something was stuck in the box. The same thing happened to me lol.
Lol
Don't cancel this, very informative, I am working on the bronco stock length as well, what do you think if even possible the tarantula with rear steer?
My bad for the lead reply. The Tarantula with rear steer, I've seen it done so it is possible.
Hey what are the little washers for? 😅 i mountet the axles yesterday but i have this 4 suckers left.... where did they have to go?
I'm not a hundred percent sure, I will be looking into it.
Pretty sure they go against the axle housing where the pin goes for the axle nut
But why... there is no need right? @@allgutsnoglorywtg
I would like to know as well. I will update this comment if I find out.
have you used this axles? I have them but I can't use them with the 7kg servo because the servo touches the motor even with the stock trx4m touches, seems that probably only works with the 11kg
I am using the axles with a 7kg and the Injora Micro Brushless MBL32 ESC & 1721 Purple Viper Motor. I have NO problems. You can try a INJORA MB100-R80 Brushed Mini ESC 20A if you are running a brushed setup, that should STOP the touches. ( NOTE: touches usually occur from lack of power from Traxxas ECM. )
👍🏾
👍🏽