I built a small camper, starting with a scratch built aluminum trailer, then 5/8 inch hardwood plywood for the exterior, an inch of polyiso insulation and 1/4 plywood for the interior. I covered the frame with black Monstaliner and the cabin with desert sand Monstaliner. One thing I noticed in this video is that he didn't do the base coat prep work that Monstaliner says is critical. We (my wife and I) started with sealing all of the wood with spar urethane before we assembled anything. Then the frame was painted with automotive primer (all of the metal parts of the camper that were covered with the Monstaliner were primed first). For both wood and metal, we covered everything with the 'required' coat of Monstaliner's 'chassis saver'. Then we rolled on the actual Monstaliner top coat. I'm not sure that leaving out the base coats will result in a long lasting finish.
Great show of patience it’s looks great. I have used this stuff many times on Jeep bumpers and trim pieces. They need to address the roller issue. The rollers fall apart during the second coat almost immediately due to the thickness. Word of advice clean once ever 4-5 months with 303 protectant spray it makes the paint pop again.
@@johndoe-wk1ru Air Force barracks. So as long as you're not underage drinking, nobody cares. I've seen people ripping out engines and transmissions. It wasn't until much later that I learned that the base has a paint shop you can rent. Would've been super helpful.
Riiiight. I have 2 Jeep Cherokees ('91 Ltd Ed. and a '94 Country). If you ever find yourself making travel plans to come to the US, more specifically Texas (Tom Green County), I'll sell you one. Take care, BrandyF from West Texas.
BE CAREFUL with the sanding in prep for painting!! - i did that too and didn't realize the clear coat would start to come up which it did about a year after it was painted!!
I got some black monstaliner to roll on for my new bumper but I think I'm going to see how much it will cost to have it sprayed on for the body. Good job though for doing it in a parking lot.
I mainly used that sanding brush. It was like 80grit. Self-etch primer for bare metal and all-surface for badging and plastic. Areas of good paint were just roughed up with the brush or included scouring pads.
So you just sanded the car and put that paint on it? Only primer on the logo's and stuff? I don't understand what you did on the inside of the doors ... rustoleum? Just rust prevention?
Not sure if people think I'm joking or not, but it is literally Lead-based paint. Lead Chromate is used to make the vivid yellow and orange colors. It's not dangerous though because it's all locked up in the epoxy substrate.
Авто/Мото
![[BLACKSWAN] ‘Roll Up’ Official Music Video](http://i.ytimg.com/vi/ulvCwyKrwqw/mqdefault.jpg)
I built a small camper, starting with a scratch built aluminum trailer, then 5/8 inch hardwood plywood for the exterior, an inch of polyiso insulation and 1/4 plywood for the interior. I covered the frame with black Monstaliner and the cabin with desert sand Monstaliner. One thing I noticed in this video is that he didn't do the base coat prep work that Monstaliner says is critical. We (my wife and I) started with sealing all of the wood with spar urethane before we assembled anything. Then the frame was painted with automotive primer (all of the metal parts of the camper that were covered with the Monstaliner were primed first). For both wood and metal, we covered everything with the 'required' coat of Monstaliner's 'chassis saver'. Then we rolled on the actual Monstaliner top coat. I'm not sure that leaving out the base coats will result in a long lasting finish.
Great show of patience it’s looks great. I have used this stuff many times on Jeep bumpers and trim pieces. They need to address the roller issue. The rollers fall apart during the second coat almost immediately due to the thickness. Word of advice clean once ever 4-5 months with 303 protectant spray it makes the paint pop again.
Was he painting his car in some random parking lot? 😂 🍒
Looks like the barracks parking lot. Don't let the 1SG catch you!
@@johndoe-wk1ru lol 1sgt won’t be found anywhere near base on a weekend.
@@johndoe-wk1ru Air Force barracks. So as long as you're not underage drinking, nobody cares. I've seen people ripping out engines and transmissions.
It wasn't until much later that I learned that the base has a paint shop you can rent. Would've been super helpful.
Great video, great results for diy.
Removing the old bedliner was so satisfying to watch
Indeed, oddly satisfying.
Excellent video!
Looking for my own Cherokee XJ here in Belgium ... already got a list of things I want to do with the car. LOL
Riiiight. I have 2 Jeep Cherokees ('91 Ltd Ed. and a '94 Country). If you ever find yourself making travel plans to come to the US, more specifically Texas (Tom Green County), I'll sell you one. Take care, BrandyF from West Texas.
Very cool. I love the orange. I have an old CJ which may get this application. I don’t know how this got recommended to me, but am glad that it was.
This guy is so wholesome
Dude, yes. Looks dope
BE CAREFUL with the sanding in prep for painting!! - i did that too and didn't realize the clear coat would start to come up which it did about a year after it was painted!!
Great video man! Also you have a voice for radio/RUclips videos lol
Agreed!
Thank you
I got some black monstaliner to roll on for my new bumper but I think I'm going to see how much it will cost to have it sprayed on for the body. Good job though for doing it in a parking lot.
You’re screwed man the deer will never see you coming lol
Dude bread is terrible for ducks. feed them grapes n shit
I hope you still have this XJ, this looks great. What did you sand with? did you use any primer after sanding the body?
I mainly used that sanding brush. It was like 80grit. Self-etch primer for bare metal and all-surface for badging and plastic. Areas of good paint were just roughed up with the brush or included scouring pads.
I just had someone recomend this to me on my xj.
It's a huge 4WD traffic cone made by Jeep!!
Surely nobody will run over him.
@@brandyf1932 heck it might be a way to make some extra cash on the side lol
IT'S NOT A CAR!!!🇺🇸😘
thank you.
It's a piece of junk lmao
Its a classic capable Jeep with lots of possibilities
Is that the "road rash" color because I am going to do my TJ that color this spring?
Apocalypse Orange.
@@gui577b I like it!! Nice comeback!
I’m confused isn’t the 2 gallon kit 275? Where do the other $500 in expenses come in?
Little purchases like extra rollers and stuff from the hardware store. It all adds up quick.
Great vid! How many coats? And would you do this again? Tks
2 coats on the main body. I would absolutely do it again, but maybe spray it instead of roll it.
@@gui577b I'm considering rolling on. Can I ask why you would spray if you could do it again?
sweet. how is this holding up?
how has it held up?
How many cans did it take total and how many coats did you get ?
2 gallon cans for two coats of the orange, 2 pints for the black.
Here's an alternate method that also uses rollers: ruclips.net/video/9gDz5W9s4Ps/видео.html
Where can I get it love that color
So you just sanded the car and put that paint on it? Only primer on the logo's and stuff?
I don't understand what you did on the inside of the doors ... rustoleum? Just rust prevention?
Correct. The inside doors were sanded and sprayed with Rustoleum bedliner for purely aesthetic purposes.
Hows it held up?
Could you not use a wider type roller for the larger expanse areas....??
No. You are fully panicking when rolling it on so more tools are just going to be a distraction.
👍🏼👍🏼👍🏼
Orange peel texture on your orange jeep!
Which color was this??
a question asked a couple times but not answered, is how much actual paint was used to get 2 complete coats?
2 Gallons for the orange, 2 quarts for the black.
@@gui577b thanks...trying to get an idea so i can do my 89 toyota pickup
15:09
How is it holding up?? I'm thinking about doing mine black..but I'm afraid it'll fade after a few weeks
It's holding up great!
@@gui577b do you think color black will fade out quick??
Yeah, I have the same concern, it seems like black color will fade fast and look gross afterward.
@@mr_4point681 It absolutely holds up. Very happy with it.
What is the name of the color you chose? I really like it!
Apocalypse.
How is it holding up? Thinking of doing the same thing to my 99
It's holding up extremely well.
wonder if it could be applied with an undercoat gun?
The instructions come with provisions for spraying with a gun.
how long does the bedliner paint last?
Forever.
Indefinitely. Still looks great 2 years on.
I was going to do Isuzu trooper just like this
0:58 hahaha whenever I read the word "extreme" I do so in roughly the same way.
How's it holding up. Love the color
It looks the same 2 years later as the day I rolled it on. Very happy with the longevity.
@@gui577b tell me you did a second coat and third coat?
Do the mud stains come off easy ??
Yes, very easily.
march 2020..you still own this ? how's it holding up ?
Like new.
how is long ish term holding up?
Extremely well.
links to the decals???
surely that textured surface gave a MPG increase?
LOL.
How much did this project cost
Hard to say with all of the little items I bought for prep and finishing. I'd say around $600.
"The directions say not to add everything in the can."....tries to add all of the shit in the can. 🤦😅
Has extreme paint finish
Fears ducks
???
Why not paint over the Herculiner
To be honest? It's shit. It was wearing away and I didn't want shit undermining my hard work.
"pretty sure its lead based"
Its delicious!
Great, now you'll have to buy a stun-gun to keep the inner-city kids from licking it off!
Not sure if people think I'm joking or not, but it is literally Lead-based paint. Lead Chromate is used to make the vivid yellow and orange colors. It's not dangerous though because it's all locked up in the epoxy substrate.
How much paint did you use
2 gallons color plus 2 quarts black.
No way!!
If you're going to roller a Jeep or other ride, try this: ruclips.net/video/9gDz5W9s4Ps/видео.html
You don't have to leave the badges on everyone knows what it is lol
All that bleed through come from poor prep work.
Cool.
Damn. U shoulda just sprayed it. Now it looks like shit. Worse then the regular paint job
Rust-Oleum is better
Looks like something that came out one of our child's assess .. $800 Babys first shit. Sorry I'll stick to Rustoleum spray method
Should of raptor lined it.