The best way is to use a suction tool. Also you can make a bracket that holds the slave cylinder in a little bit while bleeding it through the bleeder only no pumping. These can sometimes be almost impossible to bleed. There is another option and that is to replace the line from the master cylinder. Replace with a braided line or as I did make one from tubbing the same diameter as the line on the slave cylinder end.
I was always taught, never grease clutch splines, dirt sticks to grease causing plate to stick.
How do you bleed it correctly
The best way is to use a suction tool. Also you can make a bracket that holds the slave cylinder in a little bit while bleeding it through the bleeder only no pumping. These can sometimes be almost impossible to bleed. There is another option and that is to replace the line from the master cylinder. Replace with a braided line or as I did make one from tubbing the same diameter as the line on the slave cylinder end.