If you dont want to spend an insane amount of money, you can get a k24a2, and reuse your k20 head for higher rpms if wanted. It will fit perfecty fine. You need an aftermarket header like the PLM K24 swap fa5/fg header, or the skunk2 header. You need to use every k20z3 sensor because the k20z3 harness wont plug into all k24 sensors (cam position, knock sensor etc etc etc) You can use all k20z3 accesories like crank pulley, water pump, idle / tensioner pulley, alternator and ac compressor. You can use the z3 ecu and harness, and all z3 motor mounts. You also need to use the k20z3 oil pan in order to fit the torque mount. All you really need to buy to make it fit is the header, CRV post mount, type s oil pump kit (or fd2 oil pump), and I'd recommend hondata to have it running correctly and safely.
Damm take video of the vehicle stop moving the cámara nausus . Just make video short and sweet .
Skunk2 Headers have been revised and released a new version over the summer to fit 8th gen Si with k24 swaps.
I saw that after I bought my plm one 😭
There are several people who still have problems with the new revised one with their k24 swapped 8th gen. It’s still hitting lol
What did you have to do in order.
If you dont want to spend an insane amount of money, you can get a k24a2, and reuse your k20 head for higher rpms if wanted. It will fit perfecty fine. You need an aftermarket header like the PLM K24 swap fa5/fg header, or the skunk2 header. You need to use every k20z3 sensor because the k20z3 harness wont plug into all k24 sensors (cam position, knock sensor etc etc etc) You can use all k20z3 accesories like crank pulley, water pump, idle / tensioner pulley, alternator and ac compressor. You can use the z3 ecu and harness, and all z3 motor mounts. You also need to use the k20z3 oil pan in order to fit the torque mount. All you really need to buy to make it fit is the header, CRV post mount, type s oil pump kit (or fd2 oil pump), and I'd recommend hondata to have it running correctly and safely.
Is there even a slight drone after swapping the header?
Nope sounds stock
Are you running the z3 oil pan or the k24 oil pan?
Z3
I love this bideeeeeoooo
Do I have to have a Hondata for the swap? And good video bro! Literally same car and color haha
I have seen it done without the Hondata but I recommend that you use one and get a tune
you do need a Hondata. It idles, but l will not run without the Hondata.
Did u have to order a idle pulley bracket?
No I used from the k20z3
What’s the part number for your centre caps?
www.ebay.com/itm/114676083025?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=n-4mpQczQ6i&sssrc=4429486&ssuid=9pmka0c9qq2&var=&widget_ver=artemis&media=COPY
@@daboii.2vthanks for the info! Like the look of the Honda centre cap over the Enkei one for the RPF1’s
How bad are vibes as a daily?
Wdym vibes ?
@@daboii.2v vibrations
how about smog?
Got the plug lol
What’s the wheel specs?
17x9 +35 on 2154517 tires
@@daboii.2v do you have any rubbing? Did you have to roll the fenders?
@@rastaman7140 rear fenders rolled