Installing Renogy DC to DC charger with MPPT in Sprinter Van | Van Build Series Ep. 42
HTML-код
- Опубликовано: 27 авг 2024
- Today I'm going to walk you through some Sprinter-specific installation things around installing this great dual-purpose DC-DC charger and MPPT Solar Charge controller.
It's both a solar charge controller and a DC-DC charger, and it's small, so if you have a tight, well, extra tight space in which to do your installation, you may want to consider this product.
By using this product, you'll have two ways to charge your battery array. 1. Solar panels and 2. Vans alternator.
STEPS FOR THE INSTALLATION OF THE 50A RENOGY DC-DC charger and MPPT:-
1. Top right spot: Black/Negative (2 gauge wire) to the Black bus bar
2. Bottom right spot: Red/Positive (2 gauge wire) to 60amp (says 65amp above) fuse and then positive bus bar
3. Bottom left spot: Red/Positive (4 gauge wire) to 60amp (says 75amp above) fuse and then to the vans starter battery/alternator (under the driver's seat)
• Renogy DC to DC Batter...
4. Top left spot: Red/Positive solar 10 gauge - wire to ON/OFF shutoff and then up to the roof to the solar panels. (NOTE: allows you to reset the charger if you ever need to)
NOTE: the Black/negative 10 gauge wire from the solar panel goes directly into my black bus bar.
5. IGN - Little green thing for "smart alternator"
6. RS485 port run to the BT-2 battery monitor (NOTE: allows you to enter custom parameter mode; will need this to tweak the parameters for the Battle Born batteries)
7. It will automatically go to "float charge mode" because I have Lithium Ion batteries.
==NOTE: Don't install the battery temp sensor for Lithium Ion batteries as they regulate themselves.==
Enjoy and make sure to subscribe to follow along with my van build!
-------------Website-------------
www.vanlifedes...
-------------Instagram-------------
/ vanlifedesigner
-------------RUclips-------------
Subscribe: www.youtube.co...
#vanbuild #vanlife #vanlifesolofemale