Hi loving the videos as ever 👍 Got a bit of an ask if possible. Please can I draw on your well of knowledge. I have a 4.4 petrol 2003 L322 HSE and for some reason the interior lights have stopped working when the doors are opened and I'm now left opening the doors with the key as the fobs stopped working too and the central locking button under the hazard warning light switch. The lights work if you press them inside except the front centre dome light. I've swapped it with the back an the same problem persists. I've checked fuses too. I've read about BCM's going into transport mode but I've no clue how to get it out of it or even if it's in it to start with. I spoke to Jaguar Land Rover Manchester an they now don't even have the software to work on my car even if I was willing to pay the £180+vat an hour for Labour/Diagnostic's. Basically if this has happened to you before or you have seen it before please help. It would just finish off the car (before the next thing crops up) Many thanks in advance for your help and time. Please keep doing the videos as they are absolutely belting 👍👍
Hi, there's a Front and Rear diff and a Transfer Case kit. Do I have to buy extra plugs because I only see 4 plugs in the kit/video. In total there's 6 plugs, two in the front and two in the rear diff. What about the transfer case plugs?
Old post so I hope you fixed it, but no. Different rear diff. Principles tbe same but the fill and drain plugs are different sizes. I’ve got an 06 jag gas engine and the front is 14mm hex for both fill and drain; 8mm hex for transfer fill and drain but rear is 14mm hex for drain but no idea what it is for the fill! I’m working my way through a load of Allen key combinations at the moment - imperial and metric !
Great video. Wud be great if you tell how much liter of fluid to put in transfer case and differential( Front and Rear)
Do you have a video for a 2012 Range Rover full size? It's still an L322, but with the 5.0SC Jaguar engine. Is the procedure the same?
Hi loving the videos as ever 👍 Got a bit of an ask if possible. Please can I draw on your well of knowledge. I have a 4.4 petrol 2003 L322 HSE and for some reason the interior lights have stopped working when the doors are opened and I'm now left opening the doors with the key as the fobs stopped working too and the central locking button under the hazard warning light switch. The lights work if you press them inside except the front centre dome light. I've swapped it with the back an the same problem persists. I've checked fuses too. I've read about BCM's going into transport mode but I've no clue how to get it out of it or even if it's in it to start with. I spoke to Jaguar Land Rover Manchester an they now don't even have the software to work on my car even if I was willing to pay the £180+vat an hour for Labour/Diagnostic's. Basically if this has happened to you before or you have seen it before please help. It would just finish off the car (before the next thing crops up) Many thanks in advance for your help and time. Please keep doing the videos as they are absolutely belting 👍👍
How much whould cost to replace front diferential if you don't do it yourself?
Can i use w 75. 90 for transfercase?
Hi, there's a Front and Rear diff and a Transfer Case kit. Do I have to buy extra plugs because I only see 4 plugs in the kit/video. In total there's 6 plugs, two in the front and two in the rear diff. What about the transfer case plugs?
Shouldn’t need new Trn case plugs if head and thread fine; just make sure you have two new copper washers though
What is the specified amount for a l322 2007 hse range rover?
In a low mileage car what time interval should this be done?
You can get recommended service intervals for your model Land Rover on our website here: www.roverparts.com/maintenance/
Would this video still apply for a 2008 ?
Old post so I hope you fixed it, but no. Different rear diff. Principles tbe same but the fill and drain plugs are different sizes. I’ve got an 06 jag gas engine and the front is 14mm hex for both fill and drain; 8mm hex for transfer fill and drain but rear is 14mm hex for drain but no idea what it is for the fill! I’m working my way through a load of Allen key combinations at the moment - imperial and metric !