That was cool seeing you run it in a real world situation. I think it sounded lean off WOT back to idle and a little lean pulling off idle. I would say you have a leak
Problem is when I let it idle for a few. It just gets richer and richer. Eventually it gets fat enough that it is hard to keep it at idle. Pull the trigger to clear it up and it’s running super fat. Blowing smoke everywhere. I actually have the idle tuned very rich trying to compensate for what I think is a leak.
Enjoyed the video sounds good. Congrats on your promotion. 👍👍
Runs pretty dang his Smitty!!! That tree just knew you needed to run that saw. 👍🏻 wind has been crazy here today also.
👍👍 looked like some really hard stuff!
Shes running good and congratulations on job
Muffler built that 590 for me and it has been a great saw. That saw is running great
glad to see you back making videos
Man that Echo is loud!!! Even with ear muffs I would get tired of hearing that all day.
It sounds lean at idle that will also make it not idle right down off wide open throttle. My echos really lean out as they warm up.
I noticed that when pulled from the cut it sounds lean with the high idle. You could be correct about an air leak. Thanks for the entertainment
My 562xp had a base gasket leak that caused the same lean high idle when pulled out of the cut
That was cool seeing you run it in a real world situation. I think it sounded lean off WOT back to idle and a little lean pulling off idle. I would say you have a leak
Problem is when I let it idle for a few. It just gets richer and richer. Eventually it gets fat enough that it is hard to keep it at idle. Pull the trigger to clear it up and it’s running super fat. Blowing smoke everywhere. I actually have the idle tuned very rich trying to compensate for what I think is a leak.