General Electric Washing Machine Not Starting - The Motor

Поделиться
HTML-код
  • Опубликовано: 1 ноя 2011
  • General Electric Washing Machine Not Starting - The Motor
    Replacement parts amzn.to/3SSBGld - paypal.me/Angeltheapplianceman
    Warning: Use the information in this video at your own risk

Комментарии • 27

  • @matthewspilotros2148
    @matthewspilotros2148 Год назад +2

    Great Video! Step by Step details and easy to understand. Good Job, I appreciate your help in this video!

  • @calmdown7452
    @calmdown7452 2 года назад +1

    Very well done.

  • @bobsoft
    @bobsoft Год назад +2

    Where is the capacitor for the original motor that was changed out as bad? Do those motors have their start/run capacitor internally?

  • @muhammadadil9373
    @muhammadadil9373 2 года назад +1

    I have a kenmore washer which runs for around 10 seconds and then trips. I noticed that the power cord gets hot. It spins when I need to drain the water and drains very well. Any idea?

  • @kelvinharris6313
    @kelvinharris6313 3 года назад

    Very good

  • @tmiller1916
    @tmiller1916 11 лет назад +1

    My schematic has a capacitor at M7, and unless it is included in the test circuit the motor will not start and the test cable will not work.

  • @mariojimenez4993

    Por favor en Español

  • @kelvinharris6313
    @kelvinharris6313 3 года назад

    I jump the door switch but it just fill an drain

  • @muhammadadil9373
    @muhammadadil9373 2 года назад +1

    I have a kenmore washer which runs for around 10 seconds and then trips. I noticed that the power cord gets hot. It spins when I need to drain the water and drains very well. Any idea?

  • @kevinkevin9448
    @kevinkevin9448 5 лет назад

    How do I check get top loader washer motor for power ????model wjrr4170g1ww ,,,.I jumped door switch and pressurized the pressure switch and still nothing ???any help please

  • @TheeMissingLinc
    @TheeMissingLinc 5 лет назад +1

    Do you know how to test a different GE top load washer motor? I have 5 wires, orange, red, yellow, black, blue. it looks to be a pretty common motor

  • @atxjax1
    @atxjax1 5 лет назад +1

    Which wires to check for ground fault? I have a washer that trips my GFCI circuit but when plugged into a regular non gfci circuit it runs fine.

  • @ScantPear
    @ScantPear 5 лет назад

    Do a full cycle on your washers

  • @habibullah2000
    @habibullah2000 11 лет назад

    I have wsm2700dawww spacemaker washer and dryer and i need to connect it directly with 120 volt ac which wire i should connect to have agitate mode and spin mode. Help plz

  • @jjrock5
    @jjrock5 5 лет назад +1

    Do these instructions apply to the GE hydrowave washers? The wire colors don’t match. Thanks

  • @theapplianceman
    @theapplianceman  11 лет назад

    Sorry I don't know anything about the spacemaker