@@propelvirtualgarage963 I just rotated it. I can feel the binding. Took it off the belt to see which part it was. There's slight pressure when rotating like I can feel the wire rubbing or something. Thanks for the help
Do the castle nuts on the axles have to be tightened all the way? When I do this I can't get the split pin through, and if I loosen it a bit so the split pin goes through then the wheels are a bit wobbly.
They should be more than tight enough not to wobble. If you could send e a video, that would help me troubleshoot it. Send to service.usa@cycleagle.com
Thank you so much for this video. It totally educated me on the adjustments. Thank you!
i cant wait for the endeavor video
Good job Russ
Where can I get the white handlebars that can be seen at the bottom board at 4:40 ?
Can you make a video on changing the belts on the x4s please.
Yes I’d like to see this as well
ruclips.net/video/wb4TqgWSbwQ/видео.html
Thank you. That is for the hubs for X4S not the belt. Is belt the same way?
The tires say "inflate to 50 psi" which is what I did. It feels pretty hard. Do you have any hints on tuning the tires?
I personally take 10 lbs out if Im offroad all day but ride them right at 50 on the street
One of my motors blew out after one use and I can't reach the cord. It's buried in there. How do I unplug the cord on the propel X4S motor?
You take the deck off to start, thats how you access the internals but how did you diagnose that you had a bad motor?
@@propelvirtualgarage963 I just rotated it. I can feel the binding. Took it off the belt to see which part it was. There's slight pressure when rotating like I can feel the wire rubbing or something. Thanks for the help
Can you make a video or a link to the Guide to the belt change?
ruclips.net/video/YsfjWuWO9Po/видео.html
@@propelvirtualgarage963 this video actually doesn't show the belt change or tension. Is there any videos on this? Thank you
@@philcantuay946 Yes, In this one Phil
ruclips.net/video/wb4TqgWSbwQ/видео.html
Do the castle nuts on the axles have to be tightened all the way? When I do this I can't get the split pin through, and if I loosen it a bit so the split pin goes through then the wheels are a bit wobbly.
They should be more than tight enough not to wobble. If you could send e a video, that would help me troubleshoot it. Send to service.usa@cycleagle.com
Mine does the same and they are tight, well i thought they where, it's my next trouble shoot
@@gregbrowne2491 Accept friend request on FB, I want to chat with you and Dave together
Also. Some times you need 2 washers to get it lined up properly. I should have mentioned that earlier
can you make a video how to change the cs battery 🙏 🙏 🙏 🙏 🙏
cs battery?
@@propelvirtualgarage963 yes