@@davidem8215 sorry don’t quite understand your comment but I did recently install the new maple leaf hop up and inner and have had no issue so far with co2 mags
@gbbrworld4759 i've had also installed maple leaf chamber but after 1 mag on co2, the maple leaf broken on fixing barrel.. the force of recoil just cut off the fixing and the barrel come out.. similar at happened to you previous.
@@gbbrworld4759 true It won't have the steel slide but if it's too expensive to do the RMR cut on the steel slide it's kind of worth it to get the aluminum one since it's already has the cut haha 😂 itss just 50% less Realistic haha haha
@@Airsoft_Nomad the rmr cut only cost me like $150. Also mos yes is factory cut but you’ll need to use an adapter plate which only has cons, one: there’s the plate and it’s hardware that can potentially fail, two those extra parts can also loosen and lose zero, three the adapter plate adds height to the optic vs a direct rmr (or whatever cut you want for your optic of choice) which allows the optic to sit lower which means less height over bore, easier sight alignment and even though it’s not a lot further down it’s still further down so the fulcrum point of “recoil” is lower and more straight back. (This isn’t much for airsoft but don’t see how it won’t help either lol)
maple leaf chamber with co2 mag.. 1 only shoot mag.. broken on inner barrel block.. just cut off and the inner barrel come off..
@@davidem8215 sorry don’t quite understand your comment but I did recently install the new maple leaf hop up and inner and have had no issue so far with co2 mags
@gbbrworld4759 i've had also installed maple leaf chamber but after 1 mag on co2, the maple leaf broken on fixing barrel.. the force of recoil just cut off the fixing and the barrel come out.. similar at happened to you previous.
This man has giant hands that Glock looks tiny 😭
You still playing then?
I do just rarely.
Weird question, how deep is the rmr cut?
3mm
Thanks you 🙏 ps was it expensive? 🤔 Because I'm debating on just getting the
gen5
@@Airsoft_Nomad gen 5 won’t have steel slide. Only aluminum. But yes the gen 3 steel was so worth it
@@gbbrworld4759 true It won't have the steel slide but if it's too expensive to do the RMR cut on the steel slide it's kind of worth it to get the aluminum one since it's already has the cut haha 😂 itss just 50% less Realistic haha haha
@@Airsoft_Nomad the rmr cut only cost me like $150. Also mos yes is factory cut but you’ll need to use an adapter plate which only has cons, one: there’s the plate and it’s hardware that can potentially fail, two those extra parts can also loosen and lose zero, three the adapter plate adds height to the optic vs a direct rmr (or whatever cut you want for your optic of choice) which allows the optic to sit lower which means less height over bore, easier sight alignment and even though it’s not a lot further down it’s still further down so the fulcrum point of “recoil” is lower and more straight back. (This isn’t much for airsoft but don’t see how it won’t help either lol)