Thanks for these! Super clear explanations. The cutting of the layer for different amounts of infill is a perfect solution for some tall plain parts and detail on top that I'm designing now.
I really wish the videos had an executive summary detailing the changes and results of each test. Some of us just want to plug in the settings and try to tune for ourselves...
What were your experiences with 0.2 nozzle settings? I'm just making some 0.2 experiments on my own and I'm not satisfied with the quality yet. Especially regarding the much loonger print time which mostly comes from volumetric speed limitation settings. Did you experience with higher values there?
Thank you for making these on ironing. much appreciated!
Thanks for these! Super clear explanations.
The cutting of the layer for different amounts of infill is a perfect solution for some tall plain parts and detail on top that I'm designing now.
So where was the actual Ironing configuration in the Quality tab?
I really wish the videos had an executive summary detailing the changes and results of each test. Some of us just want to plug in the settings and try to tune for ourselves...
i love to use it on some parts, but its always so slow doing it .. .wonder if theres a way to speed it up..
What were your experiences with 0.2 nozzle settings? I'm just making some 0.2 experiments on my own and I'm not satisfied with the quality yet. Especially regarding the much loonger print time which mostly comes from volumetric speed limitation settings. Did you experience with higher values there?