Soy de Chile, tuve que conseguir los dos repuestos en -USA, seguí las instrucciones de este video y se soluciono el problema. La indicación de error del tablero desapareció y llevo alrededor de 500-km perfectamente.
Mine had that same service shifter, all i did was go in and pull from the clip that holds it on the bezel and gave it a little more slack and put it back in the clip and the fault went off almost as if it was pulling the wires to tight, I think I'm going to replace the whole harness anyway though
I had "Service Shifter" on my 2017 Jeep Grand Cherokee for a year without any problems... Thought it was just a light bulb that burnt out since my Jeep was perfectly fine... My wife was driving to the store and called me to tell me the Jeep was bad... I went to look at it. The Jeep will turn over and start, the shifter physically shifts through all the gears and the dash shows that but the Jeep stays in neutral... Meaning engine revs, put vehicle wont move forward or reverse? Also when I hit the Start/Run button to shut down the engine the Jeep says "Can't because vehicle isn't in park" I had to pull a relay under the hood to kill the engine... Then I see that the dashboard and navigation display won't turn off until I disconnect the battery under the pass seat? Has it towed to Jeep dealer who's tellin me I need a new 1) Shifter 2) Transmission, 3) Motor Mounts 4) Battery!!! WTF! 8 thousand dollars??? 2017 Jeep Grand Cherokee only 57K Miles! No sign of ANY transmission problems before this failure... Any thoughts anyone? They got me by the you know what at the moment...
Will this process work to remove the service shifter display on a 2014 Trailhawk 3.2L for error codes U0103-00 and U1465-00? I do not have the error code P1C86-1D.
Once the steps are complete will the code automatically clear itself, if that was the issue causing the code? Or do I need to do something additional (or take it to an auto supply shop, etc) to clear the code? Thanks!
How were you able to get your hand down in there far enough to remove and replace the wire? I have all the parts and was able to get to that step, but I stopped for fear that I'd never get the new wire plugged back in.
If I remember correctly, it was difficult. I think I was able to get enough fingers onto the wiring clip to unhook/hook, while pulling up on the molding with my right hand.
Hi I’m having an issue we’re vehicle says to shift vehicle into park and then select gear. Have to turn car off and then back on and is fine. Is this the same issue
Thank you. It took 15 minutes. Actually 20 to get out the right tools for the clips
Soy de Chile, tuve que conseguir los dos repuestos en -USA, seguí las instrucciones de este video y se soluciono el problema. La indicación de error del tablero desapareció y llevo alrededor de 500-km perfectamente.
Hola tengo el mismo problema. Me puedes indicar porfavor donde encontraste el repuesto
Just picked up the parts ( bezel and harness, 190.00 here in NY). Had it fixed in 20 minutes! Thanks
Fantastic!
Use the right tools 15, 20 minutes. Hardest is getting the bottom wire harness off and the new one in. Right color is defined by your vin number 😊
Your video was very helpful thank you god bless!!!!
Thank you so much this is super helpful!
Thanks saved alot of money!
awesome to hear!
Yea my Jeep turns off and says service shifter I already brought a WHOLE new shifter so all I needed was a new bezel
Mine had that same service shifter, all i did was go in and pull from the clip that holds it on the bezel and gave it a little more slack and put it back in the clip and the fault went off almost as if it was pulling the wires to tight, I think I'm going to replace the whole harness anyway though
Yea that little 90 degree fold right with that white clip attachment? Thats an awful design
Can I just replace wire or the gotta do bezel to
I had "Service Shifter" on my 2017 Jeep Grand Cherokee for a year without any problems... Thought it was just a light bulb that burnt out since my Jeep was perfectly fine... My wife was driving to the store and called me to tell me the Jeep was bad... I went to look at it. The Jeep will turn over and start, the shifter physically shifts through all the gears and the dash shows that but the Jeep stays in neutral... Meaning engine revs, put vehicle wont move forward or reverse? Also when I hit the Start/Run button to shut down the engine the Jeep says "Can't because vehicle isn't in park" I had to pull a relay under the hood to kill the engine... Then I see that the dashboard and navigation display won't turn off until I disconnect the battery under the pass seat? Has it towed to Jeep dealer who's tellin me I need a new 1) Shifter 2) Transmission, 3) Motor Mounts 4) Battery!!! WTF! 8 thousand dollars??? 2017 Jeep Grand Cherokee only 57K Miles! No sign of ANY transmission problems before this failure... Any thoughts anyone? They got me by the you know what at the moment...
Does this fix work on a 2015 model also? thank you very much
To replace this should I take off the battery from the truck?
Will this process work to remove the service shifter display on a 2014 Trailhawk 3.2L for error codes U0103-00 and U1465-00? I do not have the error code P1C86-1D.
Once the steps are complete will the code automatically clear itself, if that was the issue causing the code? Or do I need to do something additional (or take it to an auto supply shop, etc) to clear the code? Thanks!
Sorry for my ignorance but my jeep is turning a light that said services shifter. Is this what I need to replace?
Yes, it sounds like the same error that I had.
What are the symptoms of this code??
What were the symptoms with this message service shifter?
How were you able to get your hand down in there far enough to remove and replace the wire? I have all the parts and was able to get to that step, but I stopped for fear that I'd never get the new wire plugged back in.
If I remember correctly, it was difficult. I think I was able to get enough fingers onto the wiring clip to unhook/hook, while pulling up on the molding with my right hand.
Shifter Bezel - Mopar (5YD27XSAAA)
Hello, were can I order this ?
What happened when you got that message and then you jeep shuts off ?
what happens when you do this and it doesn't correct the problem?
Hi I’m having an issue we’re vehicle says to shift vehicle into park and then select gear. Have to turn car off and then back on and is fine. Is this the same issue
Possibly, do all the lights on the shifter light up?
@@FastHemithis is the issue I’m having now. All my lights are blinking, but will not let me take my car out of neutral.
Is this a recall issue? My 2018 just started doing this with 61K miles. I turned off the car and it reset.
I have not heard of a recall yet. Mine was out of warranty so I replaced it myself.
File complaint with NHSTA and if they get enough they'll have Chrysler to do recall. I filed one today
Hello 👋 where do I find this part ? Do you have a link ?
Does this drain the battery in your car??
Not that I’m aware of
whete do you order the parts?
I believe that I bought them on eBay
Thanks for the video do you know the part numbers?
Nevermind I saw them at the end of the video thanks!
Thanks. I’ll add them to the description asap.
Does the wire harness come the the bezel?
Two different parts
A more detailed video of the process: ruclips.net/video/JUmaWfwG9Mw/видео.html
Hello, were can I buy does parts?
I ordered mine on eBay
what is the part needed
No es 2017
so what is the part #?
end of the video, thanks
Did you have to replace the bezel too or just the harness?
You could try replacing one or the other, but the info that I had found indicated that both should be replaced while you have everything taken apart.
@@gcs909 thank you, very helpful 👌