Time to Start on the Neck | Building an Acoustic Guitar
HTML-код
- Опубликовано: 28 авг 2024
- With the body almost complete, I think its time to get to work on my acoustic guitar neck. I'm starting with a neck blank that my friend Thomas sent to me. I made a couple modifications to it to make it fit my needs. I then cut it to length, routed the truss rod channel as well as channels for some carbon fiber rods. Then I attached the head plate, and got the headstock cut to size on the router table. This is a good start to the neck.
-- My Amazon Affiliate Store for recommended products--
www.amazon.com...
My favorite double sided tape. - • The Best Double Sided ...
Installing the Binding and Purfling - • Installing Binding and...
Building my Binding Jig - • Building my Router Bin...
-- Visit My Website--
www.homebuiltw...
-- Check Out My Handmade Guitars --
www.hayleyguit...
-- Save 10% and get some awesome CA Glue from Starbond --
bit.ly/2WJmxbL
-- Ways To Support HBW --
www.homebuiltw...
-- My TeeSpring Store --
teespring.com/...
-- My Amazon Affiliate Store for recommended products--
www.amazon.com...
-- Join the HBW Built not Bought Facebook Group --
groups/homebuiltworkshop/
-----Connect on Social Media-----
/ homebuiltshop
/ homebuiltshop
/ homebuiltshop
/ homebuiltshop
----- My Mailing Address -----
Home Built Workshop LLC
P.O. Box 84
Peyton, CO 80831
-- Join in on My Weekly Live Stream (events calendar) --
www.homebuiltw...
Please remember when using tools of any type, there is the potential for injury. You are responsible for your own safety. Make sure you know how to use your tools properly, work at your own risk, be safe, wear your safety gear, and most of all, have fun!
#acousticguitar #guitarbuilding #homebuiltworkshop
Thanks tutorial and education, good job brother👍
Nice Job man
😀
Yeah, I'm excited. I'm ready to get this wrapped up.
Your method for the head plate harder than it needs to be. Take two pieces of square ply one atop the other, run the edge over the table saw with the blade tilted at the same angle as your headstock, say 13 degrees. Now you’ve got a jig with a 13 degree edge you can place the head plate in between, secure, and table saw or plane off the edge to meet that angle.
Then the work is done. Glue it on and good to go
Greetings to the craftsman!😉What is the length of the rod-truss rod that you put?And what is the total length of the whole neck?I am planning to build my first guitar.🙂
do you have a video for the truss rod channel jig?