You guys are seriously awesome. I was nervous to start popping dash pannels to install my OEM switches, this was exactly what I needed. Been shoping CR for my vehicles for years, and this is why!
There are a few threaded holes on the fender side of the firewall behind the battery. I used a 10mm M6 1.00 pitch to mount the relay and a 10mm M8 1.25 right next to it for the ground that I shortened to about 4 inches.
Unfortunately not a video for that, but it also depends on wire harnesses. We have several different harnesses that could go to switches! If you have more in depth questions, definitely reach out to info@caliraisedled.com or call our main line!
Instead of running the wire to the side of the bulkhead grommet, since you are cutting the connector anyway, cut the connector first, then poke a small hole in the grommet then push the harness thru the small hole then finish as described in the video. It will seal much better. Only my opinion
You guys are seriously awesome. I was nervous to start popping dash pannels to install my OEM switches, this was exactly what I needed. Been shoping CR for my vehicles for years, and this is why!
Thanks for your support! We appreciate customers like you!
THIS IS CLUTCH! I was about to go to a shop to get the wires up but not anymore! Very confident with the install now. THANK YOU!!
Thank you! Happy to help!
Really good and informative video. I'm now confident of doing this myself and not spending hundreds of dollars for someone else to do it. AWESOME!!!!!
You got this!
There are a few threaded holes on the fender side of the firewall behind the battery. I used a 10mm M6 1.00 pitch to mount the relay and a 10mm M8 1.25 right next to it for the ground that I shortened to about 4 inches.
This is a great tip!!!
Thank you for the video!! this was the last step i had for my cali raised led ditch light kit!
Great to hear!
Nicely done boys!
No u 🤭
Can yall do a video if there’s a truck with the Aux cables?
Dropping soon!
informative video! If I was to critique... You stated youre installing switch from inside out, Is what you did, outside in? Just saying...
You get the point! 😂
Any video on multiple button setups more or less just wondering it requires a different relay for each button
Unfortunately not a video for that, but it also depends on wire harnesses. We have several different harnesses that could go to switches! If you have more in depth questions, definitely reach out to info@caliraisedled.com or call our main line!
Instead of running the wire to the side of the bulkhead grommet, since you are cutting the connector anyway, cut the connector first, then poke a small hole in the grommet then push the harness thru the small hole then finish as described in the video. It will seal much better. Only my opinion
Either way works! For us and a big plug it was easier to go around. Single or stuff wires are easier to poke through!