So if I reset everything and it works normally for a short time, but then ends up having the same issue where it cycles 3 times and shuts down to get the 2 flash code, most likely the gas valve? I replaced the flame sensor already and that did nothing.
If the heater is “Working Normally” for a short time meaning the units come on and runs for a period of time but will eventually turn off and you have already replaced the flame sensor then many times the problem comes back to a bad 60105 control board. We would want more details before saying this is for sure the problem. You can contact our technical service department at 269-685-4123 or text them at 269-447-0412
Thanks for watching! If you have any questions, please leave a comment below!
So if I reset everything and it works normally for a short time, but then ends up having the same issue where it cycles 3 times and shuts down to get the 2 flash code, most likely the gas valve? I replaced the flame sensor already and that did nothing.
If the heater is “Working Normally” for a short time meaning the units come on and runs for a period of time but will eventually turn off and you have already replaced the flame sensor then many times the problem comes back to a bad 60105 control board.
We would want more details before saying this is for sure the problem.
You can contact our technical service department at 269-685-4123 or text them at 269-447-0412